Scribd
Upload
55 views1 page

EC Assignment-1

This document contains an assignment for an electronics and communication engineering course. It includes 10 multiple choice questions from Modules 1, 2, and 4 of the syllabus covering concepts of power supplies, amplifiers, oscillators, operational amplifiers, and embedded systems. The questions assess course outcomes related to describing electronic circuits, discussing characteristics of embedded systems, and analyzing technological advances. Students are asked to answer the questions and submit their responses by November 22nd for evaluation and assessment of the specified program outcomes.

Uploaded by

lubna
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
55 views1 page

EC Assignment-1

This document contains an assignment for an electronics and communication engineering course. It includes 10 multiple choice questions from Modules 1, 2, and 4 of the syllabus covering concepts of power supplies, amplifiers, oscillators, operational amplifiers, and embedded systems. The questions assess course outcomes related to describing electronic circuits, discussing characteristics of embedded systems, and analyzing technological advances. Students are asked to answer the questions and submit their responses by November 22nd for evaluation and assessment of the specified program outcomes.

Uploaded by

lubna
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

KNS INSTITUTE OF TECHNOLOGY

DEPARTMENT OF ELECTRONICS AND COMMUNICATION ENGINEERING


ASSIGNMENT – 1
Academic Year (2023 – 24)

Semester 1st A Introduction to


Subj. Subj. Date of
Date of BESCK104C Electronics & 22/11/23
15/11/23 Code Name Submission
Assignment Communication
COURSE OUTCOMES:

CO1: Describe the concepts of electronic circuits encompassing power supplies, amplifiers. oscillators
CO2: Describe the concepts of electronic circuits encompassing oscillators and Operational amplifiers
CO4: Discuss the characteristics and technological advances of embedded systems.

Q. SYLLABUS: Module-1, 2 and 4


CO PO
No. QUESTIONS Marks
1. Draw the block diagram of DC power supply and explain the 05 CO1 1,2,3,5
individual blocks.
2. With a neat circuit diagram and waveform. Explain the working 05 CO1 1,2,3,5
operation of a full wave bridge rectifier.
3. A mains transformer having a turns ratio of 22:1 is connected to 05 CO1 1,2,3,5
a 220V r.m.s. mains supply. If the secondary output is applied to
a half-wave rectifier, determine i) secondary r.m.s voltage ii)
peak voltage and iii) regulated DC voltage across load.
4. Discuss briefly a negative feedback amplifier with block 05 1,2,3,5
CO1
diagram.
5. With circuit diagram, explain the operation of a wien bridge 05 1,2,3,5
CO2
oscillator.
6. Explain the single state astable oscillator with circuit diagram. 05 CO2 1,2,3,5
7. Define the following operational amplifier parameters value. i) 05 CO2 1,2,3,5
Open loop voltage gain ii) Output Resistance iii) Input
Resistance iv) Slew Rate.
8. Draw the Circuit diagram and input and output waveform of the 05 CO2 1,2,3,5
following operational amplifier circuits. i) Differentiator ii)
Integrator.
9. What is an Embedded system? Compare Embedded system with 05 CO4 1,2,3,5
General computer system.
10. Mention the classification of Embedded system based on 05 CO4 1,2,3,5
complexity and performance.

Signature of the Staff In charge Head of the Department

You might also like