Scribd
Upload
27 views

BEE Tutorial

This document contains a tutorial for a Computer Science Engineering class. It lists 10 questions related to circuit analysis concepts along with their corresponding course outcomes, rubric levels, and point values. Several circuit diagrams are provided as figures to accompany the questions. The questions cover topics like determining equivalent current/voltage sources, calculating power dissipation, identifying circuit elements, developing nodal/mesh equations, and finding voltage drops across resistors.

Uploaded by

Devansh Gupta
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
27 views

BEE Tutorial

This document contains a tutorial for a Computer Science Engineering class. It lists 10 questions related to circuit analysis concepts along with their corresponding course outcomes, rubric levels, and point values. Several circuit diagrams are provided as figures to accompany the questions. The questions cover topics like determining equivalent current/voltage sources, calculating power dissipation, identifying circuit elements, developing nodal/mesh equations, and finding voltage drops across resistors.

Uploaded by

Devansh Gupta
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

DAV Institute of Engineering & Technology, Jalandhar

Department: Computer Science Engineering


CAY: 2023 – 2024

Class/ Semester: CSE-A/ 1st


Subject with code: BEE (BTEE-101-18)
Tutorial No. 1
Max marks: 10
Quest. Question CO’s Marks
No. RBT Level
1 Two 100 W, 220V bulbs are required to be connected across a 400 volts supply. Find the CO1, CO2 1
value of the resistance to be inserted in the line so that the voltage across the bulbs does not L2
exceed 220V.
2 a) Find equivalent current source for the circuit – figure.1 CO1, CO2 1
b) Find equivalent voltage source for the circuit – figure.2 L2
3 Find the power dissipated in the 100 ohm resistor and find the voltage rating of the CO1, CO2 1
dependent source. Figure.3 L3
4 In the circuit configuration obtain the number of (i) circuit elements, (ii) nodes, (iii) junction CO1, CO2 1
points, (iv) no. of branches, (v) no. of meshes. – figure.4 L3
5 Develop nodal equation for the following: Figure 5&6 CO1, CO2 2
L5
6 Develop mesh equations for the following: Figure 7&8 CO1, CO2 2
L5
7 Find voltage drop between terminal a-e: Figure.9 CO1, CO2 1
L4
8 Find the voltage needed across a-b terminal so that the drop across the 10 ohm resistor is CO1, CO2 1
45V. Also find the corresponding drop across the 5 ohm resistor. Figure.10 L4

Figure 1 2 3 4 5

6 7 8

9 10

You might also like