Scribd
Upload
41 views

Micro Adjustable Mounting Bracket Installation Instructions

This document provides instructions for installing a micro adjustable mounting bracket. It includes a list of included hardware and required tools. It describes two deck mounting options and two transom mounting options. It also describes installing an optional thru-hull bushing to route the power cord through if needed. Diagrams and instructions are provided for each mounting configuration.

Uploaded by

robert spaay
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
41 views

Micro Adjustable Mounting Bracket Installation Instructions

This document provides instructions for installing a micro adjustable mounting bracket. It includes a list of included hardware and required tools. It describes two deck mounting options and two transom mounting options. It also describes installing an optional thru-hull bushing to route the power cord through if needed. Diagrams and instructions are provided for each mounting configuration.

Uploaded by

robert spaay
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

MICRO ADJUSTABLE MOUNTING

BRACKET INSTALLATION
INSTRUCTIONS

Included hardware: Installation tools:


A Qty. (1) Adjustable mounting bracket • 1/4” Allen wrench
B Qty. (4) 5/16” Mounting bracket bolts • 1/2” Wrench or 1/2” socket with ratchet
C Qty. (4) 5/16” Lock nuts • 11/32 drill bit with drill
D Qty. (4) 5/16” Fender washers
E Qty. (1) 5/16” White thru-hull bushing (optional)

MOUNTING OPTIONS
IMPORTANT: In all options the bottom of the Micro Driver Unit must be mounted above the water line of the boat.

DECK MOUNT (FIG. 1) TRANSOM MOUNT (FIG. 2)


NOTE: Before drilling holes, mock up Micro unit with spike Place bottom edge of bracket even or
higher than the boat’s water line
installed and attached to mounting bracket to
ensure no interferences in the desired mounting location. Mark and drill holes with 5/16” drill
Adjustable bit and install hardware as shown.
mounting D
bracket C
Place bracket within 3” of B
edge of mounting surface

Adjustable Mark and drill holes with 5/16” drill


mounting bit and install hardware as shown.
bracket 1/4” Allen
Wrench C

3”

1/4” Allen Wrench

D
Figure 2
C

Figure 1

THRU-HULL BUSHING FOR POWER-CORD


IMPORTANT: If using the thru-hull bushing (E) it must be installed above the water line.
Drill a hole into boat with 11/32" drill bit, insert bushing (E) and route power-cord through to 12 volt power source.
MICRO ADJUSTABLE MOUNTING
BRACKET INSTALLATION
INSTRUCTIONS (continued)

ADDITIONAL MOUNTING OPTIONS

ADAPTER PLATE (FIG. 3)


Adapter plate
To order go to power-pole.com
or an authorized dealer. Adapter plate

Adjustable
mounting bracket
C

B
D

1/4” Allen wrench

Figure 3

Adjustable mounting bracket


TRANSOM CLAMP (FIG. 4)
To order go to power-pole.com
or an authorized dealer. Transom clamp

1/4” Allen wrench

C
B

Figure 4

Need help? Contact our Technical Support Team at 1 + 813.689.9932 Option 2


©2015 all rights reserved. Power-Pole Shallow Water Anchor U.S. Patent No. 6,041,730

You might also like