Scribd
Upload
21 views

AP Ass 1

Sharayu Kondubhairy submitted assignment 1 which included a table describing 9 components on the Micro-A748 board including their voltage requirements and applications. The table lists the LCD, LEDs, I2C interface, SPI interface, UART, stepper motor, relay and buzzer, USB device port, and external interrupt switch.

Uploaded by

yuga.m.padhye
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
21 views

AP Ass 1

Sharayu Kondubhairy submitted assignment 1 which included a table describing 9 components on the Micro-A748 board including their voltage requirements and applications. The table lists the LCD, LEDs, I2C interface, SPI interface, UART, stepper motor, relay and buzzer, USB device port, and external interrupt switch.

Uploaded by

yuga.m.padhye
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Advanced Processors Lab

Assignment 1

Name: Sharayu Kondubhairy


Batch: C2
Cnum: UEC2021321

Components, Description and Application in Tabular Format

Sr Component name Voltage Required Application


No

1 LCD +3.3V A 128x64 Graphic


LCD module is
interfaced on the
Micro-A748 board
on
connector CN8. We
can read and write
data to the LCD
module.

2 LED +3.3V 8 general purpose


LED’s are provided
on the
Micro-A748 Board
in common anode
configuration.LD1 thru
LD8 are interface to
Port Pins P0.12 thru
P0.19.

3 I2C Interface +3.3V The EEPROM


(AT24Cxx) with I2C
interface has been
integrated on the
board.
The Port pins have to
be configured to
work as I2C clock
and Data lines.

4 SPI interface +3.3V The SPI interface


from the processor
is
available on the
Micro A748 board.
Devices such
as SPI based
SD/MMC Card can
be interfaced on
the board using the
SPI.
5 Serial Communication using +3.3V UART0 is connected
UART (RS232) to USB to Serial and
UART1 is connected
to COM1 which is for
RS232
interfacing.

6 Unipolar Stepper Motor +3.3V The user can


connect the
stepper motor to
connector CN9.

7 Relay and Buzzer +3.3V A general purpose


relay is connected on
the
Micro-A748 board
for the user to
interface external
high voltage devices
to main or AC supply.
The
external devices
/AC supply can be
connected on
connector CN3.

8 USB Device Port +3.3V The processor on the

Micro-A748 (LPC2148)
has a on chip USB
device controller and
driver interface.
The Micro-A748
has
connected this
interface to a USB
device
connector (USB-B
type connector).

9 External Interrupt Switch +3.3V The External Interrupt


is generated using a
switch SW17
connected to Pin
P0.30 (INT3).
Picture of Components

You might also like