Scribd
Upload
12 views

Coreldraw Driver Guide

This document provides instructions for installing and setting up the Graphtec CE1000-60 printer. It outlines steps to 1) install the printer driver software and select the correct model, and 2) configure printer settings like the paper size and plot area. It also describes how to 3) print from CorelDRAW, including setting the layout, scaling, and checking for errors in printer options.

Uploaded by

bensondestiny99
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
12 views

Coreldraw Driver Guide

This document provides instructions for installing and setting up the Graphtec CE1000-60 printer. It outlines steps to 1) install the printer driver software and select the correct model, and 2) configure printer settings like the paper size and plot area. It also describes how to 3) print from CorelDRAW, including setting the layout, scaling, and checking for errors in printer options.

Uploaded by

bensondestiny99
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 8

Driving Guide

1. Install printing programme


a. Install application software ;

Insert floppy disk with driver;

Click ‘start’ key to choose setup as ‘printer’, then double-click the column of

printer’s appending for guide of printer’s appending; click ‘next’;

select ‘local printer’ , then click ‘next’ (this process is only for LAN);

click ‘install from disk’;

b．select driver related to computer’s operation system

If you can find related operation system in driver, please make a choice. Otherwise,

you’ll have no choice.

1
c．Then select ‘OEMSETUP.INF’

d. Select Printer’s Model

‘Graphtec CE1000-60’ is suggested to be your best choice of printer’s model,

then click ‘next’ till finish;

2
2. Set Printer Model “Graphtec CE1000-60”
Make ‘Graphtec CE1000-60’ as defaulting printer, then set printer;

a. set printer’s port

It’s no need to set port if LPT1 is selected. If port is selected as COM 1 or COM 2,

please set port. ‘Flux Control’ will have to be changed to ‘Hardware’

3
b. Set Paper & Option：

（1）Change〈PAPER SOURCED〉to“CUT PAPER”


；

（2）Change〈PAPER SIZE〉to“FREE SIZE”；

（3）Change〈PLOT AREA〉to“1500×16000”. Remark: under Windows

98/ME/SE，the max. size of PLOT AREA is 3200ｘ3200ｍｍ; under Windows2000/

XP ，the max. size of PLOT AREA is 1600ｘ16000ｍｍ

4
（4）Enter <option>, select ‘programmable resolution’ as 0.1mm.

3. Use Graphtec CE1000-60 Printer in CORELDRAW


a. Manage graph：

For letters, please profile filament at first , see the picture , click Hairline Outline .

5
Then enter ‘fill’. ‘No Fill” is selected for output.

b. Rotated 90°angle for well edited letterings or graph, the output will be cut out

from landscape orientation.

6
c. Set Print：

Set “layout” as left bottom corner, set scaling as 98.5 (see picture 1)

Make sure no error with printer’s option (picture 2 is correct; picture 3 is with

error and can’t output data)

Picture 1

Picture 2

7
Picture 3

You might also like