Technical Data Sheet

Tecomid® NB40 GR30 NL

Property (dry as molded) Condition Value Unit Standard

General Properties
Abbreviation - PA6 GF30 - ISO 1043
3
Density - 1,36 g/cm ISO 1183
Melt Flow Rate 2.16kg, 270 oC - g/10’ ISO 1133
Molding Shrinkage Parallel / Normal 0,2 / 1,0 % Eurotec
Moisture Content - <0,2 % ISO 960
Moisture Absorption 50% RH, 23 oC 2,1 % ISO 62
Mechanical Properties
Stress at Break +23oC 175 MPa ISO 527
Strain at Break +23oC 3,5 % ISO 527
Tensile Modulus +23oC 9500 MPa ISO 527
Yield Strength +23oC - MPa ISO 527
Izod Impact, notched +23 oC 16 kJ/m2 ISO 180/1A
o
Izod Impact, notched -30 C 12 kJ/m2 ISO 180/1A
o 2
Izod Impact, un-notched +23 C 95 kJ/m ISO 180/1U
Izod Impact, un-notched -30 oC 80 kJ/m2 ISO 180/1U
Thermal Properties
o
Melting Temperature 10 K/min 223 C ISO 11357
o
Heat Deformation Temperature 0.45 MPa 220 C ISO 75
o
Heat Deformation Temperature 1.80 MPa 210 C ISO 75
o
Vicat Softening Temperature 50N 215 C ISO 306
Electrical Properties & Flammability
Volume Resistivity - 1E+15 Ohm.cm IEC 60093
Surface Resistivity - 1E+13 Ohm IEC 60093
Comparative Tracking Index solution A 500 V IEC 60112
o
Glow Wire Flammability Index (GWFI) 2 mm plaque - C IEC 60695
o
Glow Wire Ignitability Temperature (GWIT) 2 mm plaque - C IEC 60695
Flame Rating 0.75 mm HB - UL94
Flame Rating 1.6 mm HB - UL94

Processing Parameters
o
Drying* 80 / 2 - 4 C / hr
o
Feed Throat Temperature 60 - 80 C
o
Processing Temperature 250 - 270 C
o
Mold Temperature 60 - 100 C
Hold Pressure 50 - 100 MPa
Back Pressure Low -
Injection Speed Fast -
* Pre-drying is not necessary for materials in moisture proof closed bags.

All mentioned information in this technical data sheet present current knowledge and experience of Eurotec. The data may not be valid when this product is used in
combination with other materials such as pigments or additives. Please note that the data are given dry as molded values related to the mentioned material only.
Naturally, these data do not guarantee certain values since may vary on customers processing conditions, so they are provided for reference purposes only and should not
be used alone to create specification limits and design basis. It is strongly recommended for customers to test the product under their own processing conditions and test
facilities to determine the suitability for the required application and use.

www.eurotec-ep.com | [email protected] AG.FR.010 R:3 RD 20.03.2013