Scribd
Upload
305 views2 pages

Maf Toyota

This document provides steps to inspect a mass air flow meter and check the harness and connector between the mass air flow meter and engine control module on a 1NZ-FE engine. The steps include measuring voltage power supply to the mass air flow meter, measuring output voltage of the mass air flow meter, and checking resistance of wiring harness between the mass air flow meter and engine control module connectors.

Uploaded by

Francisco Mora
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
305 views2 pages

Maf Toyota

This document provides steps to inspect a mass air flow meter and check the harness and connector between the mass air flow meter and engine control module on a 1NZ-FE engine. The steps include measuring voltage power supply to the mass air flow meter, measuring output voltage of the mass air flow meter, and checking resistance of wiring harness between the mass air flow meter and engine control module connectors.

Uploaded by

Francisco Mora
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

ES–90 1NZ-FE ENGINE CONTROL SYSTEM – SFI SYSTEM

2 INSPECT MASS AIR FLOW METER (POWER SOURCE VOLTAGE)

(a) Disconnect the C26 Mass Air Flow (MAF) meter


connector.
(b) Turn the ignition switch to ON.
(c) Measure the voltage between the terminal of the wire
harness side connector and body ground.
Standard voltage
Tester Connections Specified Conditions
+B (C26-1) - Body ground 11 to 14 V

ES A054396E39 (d) Reconnect the MAF meter connector.


NG Go to step 5

OK

3 INSPECT MASS AIR FLOW METER (VG VOLTAGE)

(a) Output voltage inspection.


(1) Apply battery voltage across terminals +B and E2G.
(2) Connect the positive (+) tester prove to terminal VG,
and negative (-) tester prove to terminal E2G.
(3) Check the voltage.
Standard voltage
Tester Connections Specified Conditions
VG (3) - E2G (2) 0.2 to 4.9 V

A112625E01
NG REPLACE MASS AIR FLOW METER

OK
1NZ-FE ENGINE CONTROL SYSTEM – SFI SYSTEM ES–91

4 CHECK HARNESS AND CONNECTOR (MASS AIR FLOW METER - ECM)

(a) Disconnect the C26 MAF meter connector.


(b) Disconnect the C20 ECM connector.
(c) Check the resistance.
Standard resistance (Check for open)
Tester Connections Specified Conditions
VG (C26-3) - VG (C20-118)
Below 1
E2G (C26-2) - E2G (C20-116)

Standard resistance (Check for short)


Tester Connections Specified Conditions ES
VG(C26-3) or VG (C20-118) - Body
10 k or higher
ground

(d) Reconnect the MAF meter connector.


(e) Reconnect the ECM connector.
NG REPAIR OR REPLACE HARNESS OR
CONNECTOR

A107856E01

OK

REPLACE ECM

You might also like