Scribd
Upload
80 views2 pages

Gas Sensor Construction

Gas sensors consist of several key elements: a gas sensing layer to detect changes in gas concentration and produce a corresponding change in electrical resistance, typically made of tin dioxide; a heater coil of nickel-chromium to preheat the sensing layer and increase its sensitivity; electrode lines of platinum to efficiently transmit the small current produced; electrodes of gold to connect the sensing layer output to the electrode lines; and a tubular ceramic substrate of aluminum oxide to support the heating of the sensing layer between the coil and layer. A protective metal mesh is also used.

Uploaded by

Avishkar [IIT BOMBAY]
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
80 views2 pages

Gas Sensor Construction

Gas sensors consist of several key elements: a gas sensing layer to detect changes in gas concentration and produce a corresponding change in electrical resistance, typically made of tin dioxide; a heater coil of nickel-chromium to preheat the sensing layer and increase its sensitivity; electrode lines of platinum to efficiently transmit the small current produced; electrodes of gold to connect the sensing layer output to the electrode lines; and a tubular ceramic substrate of aluminum oxide to support the heating of the sensing layer between the coil and layer. A protective metal mesh is also used.

Uploaded by

Avishkar [IIT BOMBAY]
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Gas sensor construction

Gas sensor construction


All Gas sensors will consist of a sensing element which comprises of the
following parts.

1. Gas sensing layer


2. Heater Coil
3. Electrode line
4. Tubular ceramic
5. Electrode

The below image illustrates the parts present in a metal oxide gas sensor,

Gas Sensor Construction


The purpose of each of these elements is as below:
• Gas sensing layer: It is the main component in the sensor which can be
used to sense the variation in the concentration of the gases and
generate the change in electrical resistance. The gas sensing layer is
basically a chemi-resistor which changes its resistance value based on
the concentration of particular gas in the environment. Here the
sensing element is made up of a Tin Dioxide (SnO2) which is, in general,
has excess electrons (donor element). So whenever toxic gases are
being detected the resistance of the element changes and the current
flown through it varies which represents the change in concentration
of the gases.
• Heater coil: The purpose of the heater coil is to burn-in the sensing
element so that the sensitivity and efficiency of the sensing element
increases. It is made of Nickel-Chromium which has a high melting
point so that it can stay heated up without getting melted.
Page 1|2
Gas sensor construction

• Electrode line: As the sensing element produces a very small current


when the gas is detected it is more important to maintain the efficiency
of carrying those small currents. So, Platinum wires come into play
where it helps in moving the electrons efficiently.
• Electrode: It is a junction where the output of the sensing layer is
connected to the Electrode line. So that the output current can flow to
the required terminal. An electrode here is made of Gold (Au — Aurum)
which is a very good conductor.
• Tubular ceramic: In between the Heater con and Gas sensing layer, the
tubular ceramic exists which is made of Aluminum oxide (Al2O3). As it
has high melting point, it helps in maintaining the burn-in (preheating)
of the sensing layer which gives the high sensitivity for the sensing layer
to get efficient output current
• Mesh over the sensing element: In order to protect the sensing
elements and the setup, a metal mesh is used over it, which is also used
to avoid/hold the dust particles entering into the mesh and prevent
damaging the gas sensing layer from corrosive particles.

Page 2|2

You might also like