Scribd
Upload
24 views1 page

Magnet Monitor

This document provides a diagram and notes for connectivity of equipment in a control room, magnet room, equipment room, and scan room. It shows connections between a modem, network switches, computers, and magnetic instrumentation equipment. Key components include a Magmon device for cryogenic level monitoring, a modem for remote connectivity, and connections to a laptop for serial communication and monitoring of pressure transducers and cooling equipment. Power for the Magmon comes from a customer-supplied wall outlet within 6 feet.

Uploaded by

samir.ahmed7577
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
24 views1 page

Magnet Monitor

This document provides a diagram and notes for connectivity of equipment in a control room, magnet room, equipment room, and scan room. It shows connections between a modem, network switches, computers, and magnetic instrumentation equipment. Key components include a Magmon device for cryogenic level monitoring, a modem for remote connectivity, and connections to a laptop for serial communication and monitoring of pressure transducers and cooling equipment. Power for the Magmon comes from a customer-supplied wall outlet within 6 feet.

Uploaded by

samir.ahmed7577
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

GE Healthcare Technologies Rev 24-Nov-2009

Sheet Notes: 1 Customer Furnished


CONTROL ROOM
The Modem and cable Run 940 supplied in
2 Global Modem Kit. Not used when
connectivity is via the internet.
1 3 Optional: May not be present on all systems
Site Direct connection to laptop requires cross-over
Network Jack 4
type network cable.
MAGNET ROOM
5 The power source for the Magmon is from a
customer supplied (7 x24) wall outlet within 6 ft
of the Magmon (power cord is 6 ft long).
PP1
(PENETRATION
PANEL)
EQUIPMENT ROOM
1
Site Network Jack MS1-A3
E3034
MAGNET INSTRUMENTATION BOX
831
E3022 M3022 P403 LHe Sensor / 0BO Heater
5 4 FJ1 J116

MSM1 AC J5 J7 SCAN ROOM


E3023
(MAGMON3) Power NET CRYOGEN J8
LEVEL

MODEM SYS CAB CMPR1 CMPR2 LAPTOP MG3 TB1


J1 J10 J9 J12 J2 Laptop Serial Communication
FJ2 (MAGNETIC REED SWITCH)

2 940
MS1-A5-A2
MSM3 M3023 830 J1 (PRESSURE TRANSDUCER)
E3020 E3024 J117
(Global
Modem)

1 3 MS1 A2 MS1 A2
MUX RUO Signal Coldhead
Site Box 1 Pre-Amp 1
Phone FACILITY CHILLED Heat Exchanger Cabinet MS5 A1 832 2nd Stage RUO
(Optional) WATER (COMPRESSOR 1)
Jack (HEC) J2 J1
(PE)

Coolant MS1 A2
Coldhead Sleeve
RETURN RETURN
SUPPLY SUPPLY 1st Stage Diode
SIGNAL BOX 2nd Stage Diode
2nd Stage RUO
PEN CABINET J24 FLOW/TEMP
FROM IF PANEL FJ3
A1JR

J13 E3024 E3026

E3025
FJ4

Magmon3 – MR750 / MR450 / MR450w Sheet 1 of 1

You might also like