MSDS Cerox 1063 (Oxido de Cerio)
MSDS Cerox 1063 (Oxido de Cerio)
RHODIA INC.
ELECTRONICS AND CATALYSIS
CN 7500
8 Cedar Brook Drive
Cranbury NJ 08512
2. COMPOSITION/INFORMATION ON INGREDIENTS
OSHA
Component CAS Reg Number Percentage
Hazard
CERIUM OXIDE 1306-38-3 Y > 60
LANTHANUM OXIDE 1312-81-8 Y < 40
NEODYMIUM OXIDE 1313-97-9 Y < 40
3. HAZARDS IDENTIFICATION
A. EMERGENCY OVERVIEW:
Warning Statements:
DUSTS IN HIGH CONCENTRATIONS MAY CAUSE SKIN, EYE AND RESPIRATORY TRACT
IRRITATION.
Acute Eye:
Slightly irritating. May cause foreign body irritation only.
Acute Skin:
Non-irritating. Skin absorption not likely.
Acute Inhalation:
Low acute inhalation toxicity. May cause wheezing, upper respiratory tract irritation.
Acute Ingestion:
Low acute oral toxicity.
Chronic Effects:
This product does not contain any ingredient designated by IARC, NTP, ACGIH or OSHA as probable
or suspected human carcinogens. Prolonged contact may cause chronic bronchitis.
Eye Exposure:
Rinse particulate matter from eye. Seek medical attention if irritation develops or persists or if visual
changes occur.
Skin Exposure:
In case of contact, wash with plenty of soap and water. Seek medical attention if irritation developes or
persists.
Inhalation:
If respiratory irritation or distress occurs remove victim to fresh air. Seek medical attention if respiratory
irritation or distress continues.
Ingestion:
If victim is conscious and alert, give 1-2 glasses of water to drink. Do not give anything by mouth to an
unconscious person. Seek medical attention. Do not leave victim unattended.
NOTES TO PHYSICIAN:
All treatments should be based on observed signs and symptoms of distress in the patient.
Consideration should be given to the possibility that overexposure to materials other than this product
may have occurred.
Flash Point:
Not Applicable
Extinguishing Media:
Not combustible. Use extinguishing method suitable for surrounding fire.
Containment of Spill:
Follow procedure described below under Cleanup and Disposal of Spill.
Handling:
Avoid direct or prolonged contact with skin and eyes. Avoid breathing dusts.
Dry powders can build static electricity charges when subjected to the friction of conveying, mixing or
sliding. Provide adequate precautions, such as electrical grounding, or inert atmospheres when
material is used in the presence of flammable materials to prevent ignition. When used for glass
polishing, the suspension of polish becomes alkaline (pH > 8.5) following the hydrolysis of the glass. It
is strongly recommended that gloves and goggles be worn to prevent contact with skin and eyes under
these conditions.
Storage:
Store in closed containers. Store in an area that is dry.
Introductory Remarks:
These recommendations provide general guidance for handling this product. Because specific work
environments and material handling practices vary, safety procedures should be developed for each
intended application. While developing safe handling procedures, do not overlook the need to clean
equipment and piping systems for maintenance and repairs. Waste resulting from these procedures
should be handled in accordance with Section 13: Disposal Considerations.
Assistance with selection, use and maintenance of worker protection equipment is generally available
from equipment manufacturers.
Exposure Guidelines:
Exposure limits represent regulated or recommended worker breathing zone concentrations measured
by validated sampling and analytical methods, meeting the regulatory requirements. The following
limits apply to this material, where, if indicated, S=skin and C=ceiling limit:
Engineering Controls:
Where engineering controls are indicated by use conditions or a potential for excessive exposure
exists, the following traditional exposure control techniques may be used to effectively minimize
employee exposures: general area dilution/exhaust ventilation, wet processing methods to reduce dust
generation.
Respiratory Protection:
When respirators are required, select NIOSH/MSHA approved equipment based on actual or potential
airborne concentrations and in accordance with the appropriate regulatory standards and/or industrial
recommendations.
Under normal conditions, in the absence of other airborne contaminants, the following devices should
provide protection from this material up to the conditions specified by the appropriate OSHA, WHMIS
or ANSI standard(s): Air-purifying (half-mask/full-face) respirator with cartridges/canister approved for
use against dusts, mists and fumes.
Eye/Face Protection:
Eye and face protection requirements will vary dependent upon work environment conditions and
material handling practices. Appropriate ANSI Z87 approved equipment should be selected for the
particular use intended for this material.
It is generally regarded as good practice to wear a minimum of safety glasses with side shields when
working in industrial environments.
Skin Protection:
Skin contact should be minimized through use of gloves and suitable long-sleeved clothing (i.e., shirts
and pants). Consideration must be given both to durability as well as permeation resistance.
Physical and Chemical properties here represent typical properties of this product. Contact the
business area using the Product Information phone number in Section 1 for its exact specifications.
Physical Appearance:
cream colored powder solid.
Odor:
odorless.
pH:
Not Applicable
Specific Gravity:
6.8 at 20 C (68 F).
Water Solubility:
insoluble
Vapor Pressure:
Not Available
Vapor Density:
Not Available
Chemical Stability:
This material is stable under normal handling and storage conditions described in Section 7.
Conditions To Be Avoided:
dusting conditions
Materials/Chemicals To Be Avoided:
strong acids
Chronic Toxicity:
This product does not contain any substances that are considered by OSHA, NTP, IARC or ACGIH to
be "probable" or "suspected" human carcinogens.
Toxicological Information and Interpretation Ames Test: Negative. Mouse micronucleus assay:
Negative. Data for Cerium oxide.
Ecotoxicological Information:
Ecotoxological Information and Interpretation:
NOEC - no effect concentration, > 100 mg/l/96 hr, fish: Brachydanio rerio. Data for Cerium oxide
lanthanum oxide neodymium oxide.
Transportation Status: IMPORTANT! Statements below provide additional data on listed DOT
classification.
The listed Transportation Classification does not address regulatory variations due to changes in
package size, mode of shipment or other regulatory descriptors.
US Department of Transportation
Shipping Name:
NOT REGULATED
Inventory Status
Inventory Status
UNITED STATES (TSCA) Y
CANADA (DSL) Y
EUROPE (EINECS/ELINCS) Y
AUSTRALIA (AICS) Y
JAPAN (MITI) Y
SOUTH KOREA (KECL) Y
FEDERAL REGULATIONS
Inventory Issues:
All functional components of this product are listed on the TSCA Inventory.
STATE REGULATIONS:
This product does not contain any components that are regulated under California Proposition 65.
0 Flammability Rating--Minimal
0 Reactivity Rating--Minimal
Disclaimer:
The information herein is given in good faith but no warranty, expressed or implied, is made.