Scribd
Upload
115 views

Sheet Pile Design Calculation

This document summarizes calculations to determine the total active pressure on a sheet pile wall from soil weight and a surcharge load. It first calculates the soil properties, earth pressure coefficient, and pressure due to soil weight. It then calculates the force due to a strip surcharge load and the total active pressure. Finally, it determines the spring constant for the soil-structure interaction model.

Uploaded by

mostafiz18jun2007
Copyright
© © All Rights Reserved
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
115 views

Sheet Pile Design Calculation

This document summarizes calculations to determine the total active pressure on a sheet pile wall from soil weight and a surcharge load. It first calculates the soil properties, earth pressure coefficient, and pressure due to soil weight. It then calculates the force due to a strip surcharge load and the total active pressure. Finally, it determines the spring constant for the soil-structure interaction model.

Uploaded by

mostafiz18jun2007
Copyright
© © All Rights Reserved
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 5

ACTIVE PRESSURE DUE TO SOIL WEIGHT CALCULATION

Angle of internal friction, φ= 12


Saturated soil unit weight= 17.81 kN/m3
Dry soil unit weight= 9.81 kN/m3
Sheet pile width= 400 mm
1.333333 ft
Height between Ground level
& dredging level, H= 24 ft

Average dry unit weight of Soil, ϒ'= 8 kN/m3


51.38491 lb/ft3

Active earth pressure coefficient, ka= 0.65575

p'= 808.696 lb/ft2

UDL per sheet pile= 1078.261 lb/ft


1.078261 k/ft

ACTIVE PRESSURE DUE TO SURCHARGE LOAD CALCULATION

a'= 2 m
b'= 1 m
Surcharge Load, q= 40 kN/m2 (Strip Loading)
H= 6 m

Ө1 9.462322 DEGREES
Ө2 26.56505 DEGREES

Total Force per unit length due to strip loading , P= 45.60728 kN/m
3.125092 k/ft
TOTAL ACTIVE PRESSURE DUE TO SOIL WEIGHT & SURCHARGE LOAD CALCULATION

Active Pressure due to Soil Weight & Surcharge, P a= 4.203353 k/ft


SPRING CONSTANT CALCULATION

Modulus of subgrade reaction,ks


ks=C(SF)qa
C= 40(SI unit) & 12(fps un
C= 12 ( BOWLES, PG-736) SF= 3 (for cohesive soil) &
SF 3
q a= 2.78 ksf ( qa= bearing capacity computed at several depths in th

Soil spring is provided at every = 2 ft

Modulus of subgrade reaction, ks= 100.08 k/ft3


Spring Constant for Etabs Analysis= 266.88 k/ft

(Strip Loading)
CALCULATION
40(SI unit) & 12(fps unit)
3 (for cohesive soil) & 2(for cohesion soil)

d at several depths in the likely range of pile embedment depth D and q ult= qa*SF)

You might also like