RZVV-65A-R4

8-port sector antenna, 2x 694–960, 2x 1427-2690 and 4x 1695–

2690 MHz, 65° HPBW, 4x RET

All Internal RET actuators are connected in “Cascaded SRET” configuration

Uses the 4.3-10 connector which is 40 percent smaller than the 7-16 DIN connector

General Specifications
Antenna Type Sector

Band Multiband

Grounding Type RF connector inner conductor and body grounded to reflector and
mounting bracket

Performance Note Outdoor usage | Wind loading figures are validated by wind tunnel
measurements described in white paper WP-112534-EN

Radome Material Fiberglass, UV resistant

Reflector Material Aluminum

RF Connector Interface 4.3-10 Female

RF Connector Location Bottom

RF Connector Quantity, high band 6

RF Connector Quantity, low band 2

RF Connector Quantity, total 8

Remote Electrical Tilt (RET) Information, General

RET Hardware CommRET v2

RET Interface 8-pin DIN Female | 8-pin DIN Male

RET Interface, quantity 1 female | 1 male

Dimensions
Width 395 mm | 15.551 in

Length 1499 mm | 59.016 in

Depth 203 mm | 7.992 in

Array Layout
Page 1 of 5

©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 18, 2020
RZVV-65A-R4

Port Configuration

Electrical Specifications
Impedance 50 ohm

Operating Frequency Band 1427 – 2690 MHz | 1695 – 2690 MHz | 694 – 960 MHz

Polarization ±45°

Total Input Power, maximum 800 W @ 50 °C

Page 2 of 5

©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 18, 2020
RZVV-65A-R4
Remote Electrical Tilt (RET) Information, Electrical
Protocol 3GPP/AISG 2.0 (Single RET)

Power Consumption, idle state, maximum 1W

Power Consumption, normal conditions, maximum 8W

Input Voltage 10–30 Vdc

Internal RET High band (3) | Low band (1)

Electrical Specifications
Frequency Band, MHz 694–790 790–890 890–960 1427–1518 1695–1920 1920–2180 2300–2500 2500–2690
Gain, dBi 13.8 14.2 14.2 15.3 16.8 17.6 18 17.9
Beamwidth, Horizontal, 72 70 68 67 68 64 56 55
degrees
Beamwidth, Vertical, degrees 16.7 15.2 14.1 9.4 7.4 6.6 5.8 5.4
Beam Tilt, degrees 2–18 2–18 2–18 2–12 2–12 2–12 2–12 2–12
USLS (First Lobe), dB 20 19 17 18 20 19 18 17
Front-to-Back Ratio at 180°, 35 36 33 29 33 33 32 29
dB
Isolation, Cross Polarization, 28 28 28 26 28 28 28 28
dB
Isolation, Inter-band, dB 28 28 28 28 28 28 28 28
VSWR | Return loss, dB 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0

PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150 -150 -150 -150
Input Power per Port at 50°C, 300 300 300 250 250 250 200 200
maximum, watts

Electrical Specifications, BASTA

Frequency Band, MHz 694–790 790–890 890–960 1427–1518 1695–1920 1920–2180 2300–2500 2500–2690
Gain by all Beam Tilts, 13.5 13.9 13.9 14.9 16.3 17.1 17.6 17.4
average, dBi
Gain by all Beam Tilts ±0.3 ±0.3 ±0.4 ±0.5 ±0.8 ±0.6 ±0.5 ±0.7
Tolerance, dB
Gain by Beam Tilt, average, 2 ° | 13.5 2 ° | 13.8 2 ° | 13.9 2 ° | 15.0 2 ° | 16.1 2 ° | 16.9 2 ° | 17.6 2 ° | 17.2
dBi 10 ° | 13.6 10 ° | 14.0 10 ° | 14.0 7 ° | 15.0 7 ° | 16.4 7 ° | 17.3 7 ° | 17.8 7 ° | 17.6
18 ° | 13.3 18 ° | 13.8 18 ° | 13.6 12 ° | 14.7 12 ° | 16.1 12 ° | 17.0 12 ° | 17.2 12 ° | 17.0

Beamwidth, Horizontal ±2.5 ±2.4 ±2.1 ±5.6 ±6.1 ±7.1 ±5.5 ±7.3
Tolerance, degrees
Beamwidth, Vertical ±1.2 ±0.8 ±1 ±0.6 ±0.7 ±0.6 ±0.5 ±0.3
Tolerance, degrees
Page 3 of 5

©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 18, 2020
RZVV-65A-R4
USLS, beampeak to 20° above 16 14 15 14 13
beampeak, dB
Front-to-Back Total Power at 23 23 22 26 24 25 26 25
180° ± 30°, dB
CPR at Boresight, dB 16 14 15 18 20 21 20 19
CPR at Sector, dB 10 9 7 8 8 10 8 4

Mechanical Specifications
Wind Loading at Velocity, frontal 376.0 N @ 150 km/h | 84.8 lbf @ 150 km/h

Wind Loading at Velocity, lateral 192.0 N @ 150 km/h | 43.2 lbf @ 150 km/h

Wind Loading at Velocity, maximum 107.9 lbf @ 150 km/h | 480.0 N @ 150 km/h

Wind Loading at Velocity, rear 361.0 N @ 150 km/h | 81.2 lbf @ 150 km/h

Wind Speed, maximum 241 km/h | 149.75 mph

Packaging and Weights

Width, packed 523 mm | 20.591 in

Depth, packed 384 mm | 15.118 in

Length, packed 1620 mm | 63.78 in

Net Weight, without mounting kit 22.6 kg | 49.824 lb

Weight, gross 36.8 kg | 81.13 lb

Regulatory Compliance/Certifications
Agency Classification
CHINA-ROHS Above maximum concentration value
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
ROHS Compliant/Exempted

Included Products
BSAMNT-3 — Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115 mm) OD round members. Kit contains one scissor top
bracket set and one bottom bracket set.

* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance

Page 4 of 5

©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 18, 2020
BSAMNT-3

Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115
mm) OD round members. Kit contains one scissor top bracket set
and one bottom bracket set.

General Specifications
Application Outdoor

Color Silver

Dimensions
Compatible Diameter, maximum 115 mm | 4.528 in

Compatible Diameter, minimum 60 mm | 2.362 in

Material Specifications
Material Type Galvanized steel

Packaging and Weights

Included Brackets | Hardware

Packaging quantity 1

Weight, net 6.2 kg | 13.669 lb

Regulatory Compliance/Certifications
Agency Classification
CE Compliant with the relevant CE product directives
CHINA-ROHS Below maximum concentration value
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
REACH-SVHC Compliant as per SVHC revision on www.commscope.com/ProductCompliance
ROHS Compliant

Page 5 of 5

©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: August 29, 2020