Scribd
Upload
83 views

Data Logic

This document provides instructions for programming scanners via a handheld device or programming barcodes. It explains that the scanner must be placed in Programming Mode to accept commands. Programming Mode is entered by scanning the SWITCH barcode label. Only special programming barcodes are recognized in this mode. The document also provides barcodes for entering numbers, letters, and terminating a programming sequence.

Uploaded by

João Janoski
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
83 views

Data Logic

This document provides instructions for programming scanners via a handheld device or programming barcodes. It explains that the scanner must be placed in Programming Mode to accept commands. Programming Mode is entered by scanning the SWITCH barcode label. Only special programming barcodes are recognized in this mode. The document also provides barcodes for entering numbers, letters, and terminating a programming sequence.

Uploaded by

João Janoski
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Magellan® 2200VS/2200VSΩ

and 2300HS/2300HSΩ

Product Reference Guide


Programming

Programming via Handheld Device


The scanner can also accept programming via its auxiliary port using a
handheld scanning device. Eligible handheld devices must have the ability
to transmit Code 128 function codes such as the programming bar codes
presented in this manual. PSC models QuickScan® 1000 and Quick-
Scan® 6000 support this functionality. Handheld data format require-
ments (baud rate, parity, etc.) are presented in Appendix F of this manual.
Additionally the programmable feature, Aux Port Mode, must be set to
“External Handheld Input” to allow operation.

What Is Programming Mode?


Programming Mode is a state in which the scanner must be placed in
order to accept commands via programming bar code labels. When pro-
gramming using the bar code labels in this manual, the scanner is typically
placed in Programming Mode by scanning the SWITCH label.
While in the Programming Mode, the scanner only recognizes the special
programming bar codes contained in this programming guide. See
Appendix A for information about scanner indications while in the Pro-
gramming Mode.

Entering and Exiting Programming Mode.


Use the bar code label below to enter and exit (‘switch” into and out of )
Programming Mode.

SWITCH LABEL

5-4 Magellan® 2200VS/2200VSΩ and 2300HS/2300HSΩ


Programming

Global Prefix — continued


Remember to cover any unused bar codes on this and the facing page to
ensure that the scanner reads only the bar code you intend to scan.

SET GLOBAL PREFIX

TERMINATE SEQUENCE

5-54 Magellan® 2200VS/2200VSΩ and 2300HS/2300HSΩ


Use the bar codes in this section to enter numbers and characters as you
would select digits/characters from a keypad.
Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.

Product Reference Guide C-3


Use the bar codes in this section to enter numbers and characters as you
would select digits/characters from a keypad.
Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.

C-8 Magellan® 2200VS/2200VSΩ and 2300HS/2300HSΩ

You might also like