Scribd
Upload
74 views1 page

Compressor Installation Guide 22

1. It is recommended to install bypass pipes and ball valves to isolate filters and the air dryer during service without disrupting air delivery. 2. The ventilation system should avoid recirculating cooling air into the dryer inlet and limit air velocity to 5m/s with a maximum pressure drop of 30Pa, requiring a fan if exceeded. 3. The air dryer should be installed on a level floor able to support its weight.

Uploaded by

Ismail Ali
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
74 views1 page

Compressor Installation Guide 22

1. It is recommended to install bypass pipes and ball valves to isolate filters and the air dryer during service without disrupting air delivery. 2. The ventilation system should avoid recirculating cooling air into the dryer inlet and limit air velocity to 5m/s with a maximum pressure drop of 30Pa, requiring a fan if exceeded. 3. The air dryer should be installed on a level floor able to support its weight.

Uploaded by

Ismail Ali
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Installation proposal 21

FD Air Dryer

1 It is recommended to install by-pass pipes over each filter and air dryer
together with ball valves in order to isolate the filters and/or dryer during
service operations, without disturbing the compressed air delivery.

2 Ventilation:
The installation grid(s) and ventilation fan should be installed in such a
way that any recirculation of cooling air to the inlet gratings of the dryer
is avoided.

The air velocity to the grid(s) has to be limited to 5m/s.

Maximum allowable pressure drop over the cooling air ducts is 30 Pa.
When 30 Pa is exceeded, a ventilation fan is needed at the outlet of the
cooling air ducts.

3 The refrigerant air dryer should be installed on a level floor suitable for
taking the weight of the dryer.

4 Power supply cable to be sized and installed by a qualified electrician.

5 The condensate drain pipes from the dryer to the collection point must
not submerge in the collected condensate.
Do not allow untreated condensate to enter the draining system. An OSC
can be added to separate oil from the water that is coming from the
drain of the dryer. As an option you can get Integrated OSD to do this.

6 Filter type DD for general-purpose filtration (particle removal down to 1


micron with a maximum oil carry-over of 0.5 ppm). A high efficiency
PD-filter (3) installed downstream the DD- filter (particle removal down to
0.01 micron and max. oil carry- over of 0.01 ppm).
Should oil vapour and odors be undesirable, a QD active carbon filter
should be installed after the PD filter.

As an option you can get integrated filters in the dryer.

Notes:
- All pipes should be installed stress free to the dryer.
- For dimensions and air flow directions refer to the dimension drawing.

You might also like