Scribd
Upload
47 views

Evo Quick Start Guide

The EVO 4 audio interface connects to a computer via USB and requires downloading drivers from the manufacturer's website. It has inputs for two audio sources, phantom power, a volume knob, monitor mix, and output volume controls. Smartgain mode automatically sets input levels by listening to a test signal and adjusting the levels.

Uploaded by

rakapixel
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
47 views

Evo Quick Start Guide

The EVO 4 audio interface connects to a computer via USB and requires downloading drivers from the manufacturer's website. It has inputs for two audio sources, phantom power, a volume knob, monitor mix, and output volume controls. Smartgain mode automatically sets input levels by listening to a test signal and adjusting the levels.

Uploaded by

rakapixel
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Welcome to your new EVO 4 Audio Interface.

Please
read this quick guide to help get you started.

Connect Install Drivers


To connect your EVO 4 to your computer, In order to start using your EVO 4 you will need

01 02
simply plug in the USB cable provided. Once to download and install the latest drivers, which
successfully connected, EVO 4’s volume can be found at evo.audio/evo4/downloads.
wheel LEDs will illuminate and perform a Once the drivers are installed, you may be
short animation followed by the Volume prompted to update the units firmware. A full
button illuminating. installation guide can be found on our website.

4
3

The Features
5
1. Smartgain Mode

03
2. Inputs 1 + 2
3. Phantom Power 2
4. Volume knob
5. Monitor Mix
6. Output volume

1 6
04 Smartgain Mode

The Smartgain LED will start flashing


red and the volume wheel LED’s will
1 Press the Smartgain button to begin 5
illuminate indicating that Smartgain
Mode is now listening

The Smartgain LED will illuminate green


and the input channel LEDs (1 & 2) will Start playing or performing into the
2 6
begin to flash (indicating a channel microphone
must be selected)

Smartgain Mode will dial in the


Press one or more of the input channel
correct levels and when complete
3 buttons to select the channels to be 7
the Smartgain button will flash green
adjusted
twice to indicate it has been successful

Press the Smartgain button again to


4 8 You are now ready to start recording
begin the process

You might also like