Scribd
Upload
200 views

Lecture 7-2 Assembling Drawing Tutorial

This document provides two questions regarding assembling drawing tutorials. The first question asks to draw an orthographic plan view and sectional front view of a machine component shown in figure 1, without hidden details on the cut. The second question asks to draw a sectional front elevation and plan view of a detail from a stationary engine shown in the figure, with all hidden details shown and including specified dimensions, a title, and notation of the projection type used.

Uploaded by

Alhaj Massoud
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
200 views

Lecture 7-2 Assembling Drawing Tutorial

This document provides two questions regarding assembling drawing tutorials. The first question asks to draw an orthographic plan view and sectional front view of a machine component shown in figure 1, without hidden details on the cut. The second question asks to draw a sectional front elevation and plan view of a detail from a stationary engine shown in the figure, with all hidden details shown and including specified dimensions, a title, and notation of the projection type used.

Uploaded by

Alhaj Massoud
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

ASSEMBLING DRAWING TUTORIALS

QUESTION ONE
Orthographic views of a certain machine component are shown in figure 1 below, using fully size in third angle
projection, with items correctly assembled draw
a) A plan
b) Sectional front view on cutting plane A-A
Do not show hidden details on the cut.
QUESTION TWO
Figure below shows a detail from a stationary engine. Draw this detail with the parts assembled. You may use
either first or third angle projection.
Draw, twice full size:
a) A sectional FE in the direction of arrow B. The section should be parallel to the sides of the rod and
pass through the center of the hinge bolt.
b) A plan in the direction of arrow A and projected from the elevation. Show all hidden detail in this
view:
i) The smallest diameter spigot on the bolt should be shown threaded M10 for 15mm and the bolt
should be fastened by an M10 nut;
ii) Six main dimensions should be added to the views;
iii) Print the title ‘ Safety valve operating link detail ’ in the bottom right-hand corner of your sheet
in 6 mm letters;
iv) In the bottom left-hand corner of the sheet print the type of projection you have used. East
Anglian Examinations Board

You might also like