Scribd
Upload
14 views23 pages

Surajit Das Bauri Roll 15801622025 Ee Sem Vi Sub Digital Signal Processing

The document discusses sampling and reconstruction of signals. It explains key concepts like the Nyquist rate, aliasing, quantization, and how analog signals are converted to digital signals via sampling and then back to analog via reconstruction. Formulas for sampling, reconstruction, and the relationship between analog and digital frequencies are provided.

Uploaded by

Doel
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
14 views23 pages

Surajit Das Bauri Roll 15801622025 Ee Sem Vi Sub Digital Signal Processing

The document discusses sampling and reconstruction of signals. It explains key concepts like the Nyquist rate, aliasing, quantization, and how analog signals are converted to digital signals via sampling and then back to analog via reconstruction. Formulas for sampling, reconstruction, and the relationship between analog and digital frequencies are provided.

Uploaded by

Doel
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 23

MALLABHUM INSTITUTE OF TECHNOLOG

(Approved by: AICTE & Affiliated to Maulana Abul Kalam Azad University of Technology)
Campus: Bishnupur, Dist.: Bankura, (W.B)

 Full Name : S U R A J I T DA S B AU R I
 University Roll No : 15801622025

 University Reg. No: 221580120230

 Department : E L E C T R I C A L E N G I N E E R I N G

 Subject Name : D I G I TA L S I G N A L P R O C E S S I N G

 Code : OE-EE-601A

 Semester : 6 TH
Sampling and Reconstruction of Signals
Sampling

▶ To use digital signal processing techniques on continuous-time signals, we


need to them into a sequence of numbers. This is done by taking samples of
the analog signal periodically (one evert T seconds):

▶ The sampling frequency has to be large enough so that the signal


can be recovered from the samples x[n]. The limit is the Nyquist rate that is
twice the highest frequency of the analog signal. That is, if the highest
frequency of the signal is B Hz. the sampling rate need to be greater than (or
at least equal to) 2B samples per second.
Sampling

▶ If the signal x a t is an aperiodic signal with finite energy, its spectrum is:

▶ And it can be recovered from its spectrum using:


Sampling

▶ The spectrum of a discrete-time signal is:

▶ Or equivalently,
Sampling

▶ The signal x[n] can be recovered from the spectrum:

The relationship beteen time in analog domain (t) and digital domain (n) is:
Sampling

▶ In fact x[n] represents a sequence of samples of the analog signal at time nT:

So,

The relationship between analog and digital frequencies is:


Sampling

▶ Substituting in in the equality in the previous slide, we get:

So,

▶ The right-hand side can be written as,


Sampling
▶ We observe that X a (F) in the interval k — 1 Fs to k + 1
Fs is identical to
2 2
X a (F —kFs ) in the interval —Fs /2 to Fs /2, so:

We have used the fact that


Sampling
▶ Comparing the equations in the previous two slides, we get,

▶ Or equivalently,

▶ So if Fs ≥ 2B, that is, if the sampling rate exceeds the Nyquist rate, the
analog signal, then the analog signal can be recovered from the samples,
Reconstruction
▶ Given the sampled signals spectrum X(f), we get,

▶ From Fourier transform,

▶ We have
Reconstruction
Aliasing: s
Reconstruction: s
Reconstruction: s
Sampling (Nyquist) Theorem
Sampling: Example
▶ Speech Signals mainly contain components in frequencies less that 3400 Hz.
So, 6800 samples per second is the minimum sampling rate. To make
reconstruction easier (less sharp filters) 8000 samples are taken per second.
That is one sample every T = 1 μs (micro-seconds).
▶ Audio contains frequencies up to 20 kHz. So minimum is 40,000
samples/sec. Usually 44.1 k samples are taken each second.
▶ Video: The number of samples for a video signal depends on the number of
pixels (picture elements) per frame and the number of frames per second.
Discrete-Processing of Analog Signals
▶ First the analog signal is digital signal using Analog-to-Digital (A to D or A/D)
converter, then it is processed by the Discrete-Time (most often Digital)
system and then reconverted to Analog using D/A converter.
Quantization
Quantization
Quantization
Quantization Error
Quantization Error : Example

You might also like