Scribd
Upload
34 views

JFORM

This document appears to be a form for documenting the inspection and maintenance of a mechanical joint. It includes sections for identifying the joint and part details, disassembling and inspecting the joint, reassembling the joint ensuring proper alignment and torque values are met, inspecting the completed joint, and signing off on the joint acceptance. The form includes fields for equipment number, drawing number, joint number, flange details, bolt details, inspection results, and sign-offs from different parties to indicate the joint passed inspection and was properly reassembled.

Uploaded by

Mohd Effiezool Yaser
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
34 views

JFORM

This document appears to be a form for documenting the inspection and maintenance of a mechanical joint. It includes sections for identifying the joint and part details, disassembling and inspecting the joint, reassembling the joint ensuring proper alignment and torque values are met, inspecting the completed joint, and signing off on the joint acceptance. The form includes fields for equipment number, drawing number, joint number, flange details, bolt details, inspection results, and sign-offs from different parties to indicate the joint passed inspection and was properly reassembled.

Uploaded by

Mohd Effiezool Yaser
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

INTEGRATED TURNAROUND MAIN MECHANICAL &

MAINTENANCE MECHANICAL STATIC (TA4MS)


JFORM - UPV

SECTION I - JOINT IDENTIFICATION & PART DETAIL DATA SECTION IV - CONTROLLED BOLTING, JOINT INSPECTION & COMPLETION

Equipment No. :
critical joint

Drawing No. 1st Pass @ 2nd Pass @ 3rd Pass @ 4th Pass @ 100% 5th Pass @ 100% (after
Passes
Joint No. 30% 60% 100% (circular clockwise) 4 hour)

Flange Size
Torque
Bolt Size Value

Flange Type RF / FF / RTJ / OTHERS


A
A
Flange Rating 150 / 300 / 600 / 900 / 1500 / 2500
A B C D
Bolt Material B7 / L7 / B8 / OTHER (COATED / UNCOATED) C D D C
Gasket Type SPW / EPDM / MG / RTJ / ORING / OTHERS Gap(mm)
B A
*Gasket Size OD/ID x THK Alignment (mm)
* if applicable

SECTION II - JOINT DISASSEMBLY AND INSPECTION Uniform gap between flanges YES NO
Flange Surface Condition : Any marks or indetations ? YES NO Mating Flange aligned YES NO
Verifier Acceptance NA ACC REJ At least 2 full thread protrude from each nuts YES NO

Flange Required Remachining / Replacement ? YES NO Equal bolt protrude length YES NO

Bolt Replacement Required ? YES NO Bolt Loose YES NO

SECTION III - JOINT ASSEMBLY SECTION V - JIT TAGGING 1/2


Gasket Seat Cleanliness YES NO Joint Identification YES NO

Flange Alignment (Angular and Linear misalignment) YES NO Joint Defect / Repaired Required NA YES NO

Fastener & Flange Surface Prep. Check YES NO Joint Set-up & Tightening YES NO

Flange Bolt Sequence Marking YES NO Joint Completion YES NO

Correct Gasket Install YES NO

Repaired / Flange Machining Done NA YES NO


INTEGRATED TURNAROUND MAIN MECHANICAL &
MAINTENANCE MECHANICAL STATIC (TA4MS)
JFORM - UPV

SECTION V - JIT TAGGING COLUMN & COMMENT (2/2)

SECTION V - JOINT ACCEPTANCE


JIT CONTRACTOR CONTRACTOR PRPC-UF

You might also like