Subject Code: XXXXX

Roll No:

BTECH
(SEM-5) ADVANCE WELDING 2021-22

TIME:3 HOUR Total Marks: 100

Instruction: Attempt the questions as per the given instructions. Assume missing data suitably.

SECTION - A

Attempt All Parts in Brief 2*10 = 20

Q1 Questions Marks

(a) What is the function of flux in the welding? 2

(b) What is the principle involved in resistance welding ? 2

(c) Draw the weld symbols for double U and single V joint. 2

(d) How radial friction welding is used to join the collars shaft and tube? 2

(e) What are the effects of gases in welding ? 2

(f) Define the health and safety in welding. 2

(g) How is the carbon equivalent value calculated ? 2

(h) Write short note on the bend test. 2

(i) Describe the factors affecting weldability of copper alloys. 2

(j) Describe the are blow. 2

SECTION - B
Attempt Any Three of the following 3*10 = 30

Q2 Questions Marks

(a) Describe TIG welding process with neat sketch. What are the advantages and limitation of TIG welding over 10
MIG welding ?

(b) The DC are current has voltage - length characteristics as V = (10 + 30L) volts. The characteristics of power 10
source is V (60 - 0.07I) volts. Determine the optimum are length and corresponding arc power.

(c) Define residual stresses in welding. State and explain the major factors responsible for residual stress. 10

(d) Briefly describe the various weld defect and distortion in welding and its causes and remedies. 10

(e) Write short note on : 10

SECTION - C

Attempt Any One of the following 5*10 = 50

Q3 Questions Marks

(a) Briefly classify the process selection criteria of welding process. 10

(b) Classify the different types of metal transfer used in various types of are welding process with neat sketch. 10

Q4 Questions Marks

(a) Describe the laser beam welding. Explain the principle behind the generation of laser with neat sketch and 10
also write the various application of laser beam welding.

(b) Define the magnetically impelled arc butt (MLAB) welding procedure, limitation and application of this 10
process.

Q5 Questions Marks

(a) Explain the factor affecting changes in microstructure and mechanical properties of heat affected zone. 10

(b) Discuss in detail about weld thermal cycles with neat sketch and also mention the factor affecting change in 10
microstructure and HAZ.

Q6 Questions Marks

(a) Discuss about the different types of weld joint with neat sketch. 10

(b) Explain the following: 10

Q7 Questions Marks

(a) What is metallizing process ? How the surface of work must be prepared for this process? Also describe the 10
nature of bond between sprayed metal and work.

(b) Discuss the effect of alloying element on the weldability. Explain the welding of dissimilar metal briefly. 10