Scribd
Upload
33 views

Basic Astable 555 Oscillator Circuit

The document describes the operation and timing of a basic 555 astable oscillator circuit. It explains that the capacitor charges through resistors R1 and R2 but discharges only through R2, causing the output to oscillate between 2/3Vcc and 1/3Vcc. Equations are provided to calculate the individual charge and discharge times, total cycle time, frequency, and duty cycle based on the resistor and capacitor values. An example calculation is also shown to illustrate how to determine the output frequency and duty cycle for a given circuit configuration.

Uploaded by

Zdravko Peran
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
33 views

Basic Astable 555 Oscillator Circuit

The document describes the operation and timing of a basic 555 astable oscillator circuit. It explains that the capacitor charges through resistors R1 and R2 but discharges only through R2, causing the output to oscillate between 2/3Vcc and 1/3Vcc. Equations are provided to calculate the individual charge and discharge times, total cycle time, frequency, and duty cycle based on the resistor and capacitor values. An example calculation is also shown to illustrate how to determine the output frequency and duty cycle for a given circuit configuration.

Uploaded by

Zdravko Peran
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

Basic Astable 555 Oscillator Circuit

In the 555 Oscillator circuit above, pin 2 and pin 6 are connected together
allowing the circuit to re-trigger itself on each and every cycle allowing it to
operate as a free running oscillator. During each cycle capacitor, C charges
up through both timing resistors, R1 and R2 but discharges itself only
through resistor, R2 as the other side of R2 is connected to
the discharge terminal, pin 7.
Then the capacitor charges up to 2/3Vcc (the upper comparator limit) which
is determined by the 0.693(R1+R2)C combination and discharges itself
down to 1/3Vcc (the lower comparator limit) determined by
the 0.693(R2*C) combination. This results in an output waveform whose
voltage level is approximately equal to Vcc – 1.5V and whose output “ON”
and “OFF” time periods are determined by the capacitor and resistors
combinations. The individual times required to complete one charge and
discharge cycle of the output is therefore given as:

Astable 555 Oscillator Charge and Discharge Times

Where, R is in Ω and C in Farads.


When connected as an astable multivibrator, the output from the 555
Oscillator will continue indefinitely charging and discharging between
2/3Vcc and 1/3Vcc until the power supply is removed. As with the
monostable multivibrator these charge and discharge times and therefore
the frequency are independent on the supply voltage.
The duration of one full timing cycle is therefore equal to the sum of the two
individual times that the capacitor charges and discharges added together
and is given as:

555 Oscillator Cycle Time

The output frequency of oscillations can be found by inverting the equation


above for the total cycle time giving a final equation for the output
frequency of an Astable 555 Oscillator as:

555 Oscillator Frequency Equation

By altering the time constant of just one of the RC combinations, the Duty
Cycle better known as the “Mark-to-Space” ratio of the output waveform
can be accurately set and is given as the ratio of resistor R2 to resistor R1.
The Duty Cycle for the 555 Oscillator, which is the ratio of the “ON” time
divided by the “OFF” time is given by:

555 Oscillator Duty Cycle


The duty cycle has no units as it is a ratio but can be expressed as a
percentage ( % ). If both timing resistors, R1 and R2 are equal in value,
then the output duty cycle will be 2:1 that is, 66% ON time and 33% OFF
time with respect to the period.

555 Oscillator Example No1


An Astable 555 Oscillator is constructed using the following components, R1 =
1kΩ, R2 = 2kΩ and capacitor C = 10uF. Calculate the output frequency from the
555 oscillator and the duty cycle of the output waveform.
t1 – capacitor charge “ON” time is calculated as:

t2 – capacitor discharge “OFF” time is calculated as:

Total periodic time ( T ) is therefore calculated as:

The output frequency, ƒ is therefore given as:

Giving a duty cycle value of:

As the timing capacitor, C charges through resistors R1 and R2 but only discharges
through resistor R2 the output duty cycle can be varied between 50 and 100% by
changing the value of resistor R2. By decreasing the value of R2 the duty cycle
increases towards 100% and by increasing R2 the duty cycle reduces towards 50%.
If resistor, R2 is very large relative to resistor R1 the output frequency of the 555
astable circuit will determined by R2 x C only.

You might also like