Scribd
Upload
105 views1 page

Piping Flange Alignment Report

The document reports on the alignment of piping flanges on a project. It includes measurements of parallelism, face alignment, centerline position, spacing or gaps between flanges, and rotational alignment of holes. Remarks and test equipment used are also noted.

Uploaded by

kostas.barlas.01
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
105 views1 page

Piping Flange Alignment Report

The document reports on the alignment of piping flanges on a project. It includes measurements of parallelism, face alignment, centerline position, spacing or gaps between flanges, and rotational alignment of holes. Remarks and test equipment used are also noted.

Uploaded by

kostas.barlas.01
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Piping Flange Alignment Report

Project Report No
Location Date
Equipment Tag No.
System Sub System
Drawing No.

Equip. Tag No. Line No. Flange Join No.


Parallelism
Face Alignment Value X (mm) Result
A
B
C
D
Centreline High/Low
Face Offset Value Z (mm) Result
A
B
(The tolerance is 1.5 mm (1⁄16 in.) at any point)

Excessive Spacing or Gap


Face Offset Value Y (mm) Result
A
B
(Distance not greater than twice the thickness of the gasket when the
flanges are at rest and the flanges will not come together using
reasonable force)

Rotational-Two Hole
(The tolerance is measured by observing a 90-deg angle where the
fastener passes through the flanges, or the holes are within 3 mm (1⁄8
in.) of perfect alignment)

Maximum Measured Value (mm)

Remarks:

Test Equipment Used


Make Model Serial No. Cal. Expiry Date
Make Model Serial No. Cal. Expiry Date
Make Model Serial No. Cal. Expiry Date

Name
Signature

Date

You might also like