Scribd
Upload
17 views

3.advanced Remote Accident Report System For Highways Using GSM Network

The project aims to safeguard people and notify authorized individuals using GSM technology. It uses sensors to monitor temperature, pulse rate, and vibration, sending SMS alerts to a mobile if any exceed set points. The system has an RF transmitter and receiver, with encoding and decoding, to send sensor data to a microcontroller interfaced with a GSM modem to transmit SMS messages.

Uploaded by

Saravanan Viswakarma
Copyright
© © All Rights Reserved
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
17 views

3.advanced Remote Accident Report System For Highways Using GSM Network

The project aims to safeguard people and notify authorized individuals using GSM technology. It uses sensors to monitor temperature, pulse rate, and vibration, sending SMS alerts to a mobile if any exceed set points. The system has an RF transmitter and receiver, with encoding and decoding, to send sensor data to a microcontroller interfaced with a GSM modem to transmit SMS messages.

Uploaded by

Saravanan Viswakarma
Copyright
© © All Rights Reserved
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

Advanced remote accident report system for highways using GSM network

AIM:
The main objective of the project is to safe guarding the person and to inform the
authenticate person using GSM technology.

PROJECT EXPLNATION:

In this project we can use RF transmitter and RF receiver. Global System for Mobile
communication shortly termed, as GSM is the standard used by most of the mobile cellular
service providers. The Short Message Service is of a great boon to consumers who can just send
free SMS instead of making a call, which costs much. In this System we will make use of the
SMS service to monitor and control the physical parameters of temperature. The temperature
sensor will sense the temperature of the heating area, which is the input to the micro controller.
The micro controller used here is 89C51, which has an inbuilt Program Memory; We Interface
an ADC which converts the input from the temperature sensor to digital data to manipulate. The
resolution will be high because the ADC gives an 8 bit digital o/p. The temperature will be
compared with the set point and if it exceeds or goes below, a message will be send to a mobile
through a GSM MODEM. A vibration sensor is used to sense highly sensible reed relay is used
in this project encapsulated on a aluminum body can be fitted on the bike, the bike is away from
the magnetic field. The reed relay immediately responds and provides logical signal to
electronic circuits. Here the signal will be encoded by the encoder before Transmission and in
the receiver side the signal will be decoded by the decoder and then it will be feed into the
Microcontroller. Pulse sensor is used to identify the pulse rate of the person. All the details are
already programmed in the micro controller.
BLOCK DIAGRAM

RECEIVER

Pulse Temperatur
Sensor ADC e sensor

RF Decoder Micro GSM


RX controller Mobile

Vibrating
sensor

TRANSMITTER

ENCODER RF
Transmitter

You might also like