ESA500
Fixed sidelite/all glass automatic sliding door
with ESA II controller
Owner's Manual
DL-0741–050 05-2022
| EN |
ESA500 Fixed Sidelite/All Glass Automatic Sliding Door
Owner's Manual
Important Installation Instruction
ALL INSTALLATIONS SHOULD ONLY BE PERFORMED
BY TRAINED OR AUTHORIZED PERSONS
Warning - To reduce the risk of injury:
1. Carefully Read And Follow All Installation Instructions
2. This unit should only be installed in a rough opening capable of
providing proper structural support. Have a qualified service
person make repairs to surrounding electrical cables and/or
other surrounding structure to ensure proper anchoring of unit
before installation.
3. Always disconnect the power supply before servicing.
2 ESA500 DL0741-050 05-2022
ESA500 Fixed Sidelite/All Glass Automatic Sliding Door
Owner's Manual
Caution
Improperly Adjusted Door can
cause injury and equipment damage.
Inspect door operation daily
using safety checklist in
Owner’s manual and at door.
Have door adjusted as described in Owner’s Manual.
Safety devices should be in place and operational.
ESA500 DL0741-050 05-2022 3
ESA500 Fixed Sidelite/All Glass Automatic Sliding Door
Owner's Manual
To Our Customers
The purpose of this manual is to familiarize you with your automatic door system. It is
essential that you "know your system" and that you recognize the importance of
maintaining your door system in compliance with the industry standards for safety.
It is your responsibility,
as owner or caretaker of the equipment, to inspect the operation of your door system on
a daily basis to ensure that it is safe for use by your customers or employees.
This manual will provide you with a description of the operation and maintenance
requirements of your door. It also provides the instructions for the Daily Safety Check.
Should the door fail to operate as prescribed in the Daily Safety Check, or at any other
time for any other reason, do not attempt to repair or adjust the door. Call a qualified
service technician.
These technicians are trained to service your door in accordance with applicable
industry safety standards.
Service Availability
dormakaba products are distributed through a nationwide network of
dormakaba authorized distributors for sales, installation and service.
Compliance with Safety Standards
Your door system was designed to the latest operating and safety standards. In order to
ensure the continued safe operation of your door, it is important that:
- Your door system be maintained in compliance with the standards of the industry.
- Proper decals and labels be applied and maintained on your doors. If decals are
removed or cannot be read, request labels to be replaced when calling for service.
4 ESA500 DL0741-050 05-2022
ESA500 Fixed Sidelite/All Glass Automatic Sliding Door
Owner's Manual
Electric Sliding Door Installation Instructions
Instructions to Installer
We are pleased that a dormakaba automatic sliding door has been chosen for this installation.
dormakaba carefully designed, tested and built the door of high quality materials as it will provide
many years of service.
Now the door must be installed and adjusted properly to ensure its proper operation and safe use.
To install and adjust the door for proper and safe operation, the installer must carefully read this
instruction book before proceeding, then follow the instructions exactly.
The door is designed to be installed only by trained and knowledgeable installers. The installation
technician should be experienced in the installation of automatic entrances. He should know all
local code requirements and be familiar with the requirements of the current ANSI A 156.10
Standards for Power Operated Pedestrian Doors.
After installation, the door must be adjusted to conform with dormakaba recommendations and all
code requirements. Be sure to carefully study the requirements in these instructions.
After installation and adjustment, the installers final responsibility is to properly instruct the owner in
the safe use of the door. He must also present the owner with the ESA Owner’s Manual and
carefully explain how to perform the daily safety check test.
Each step of the installation, adjustment and instructions are important for proper and safe use of
the door being installed. If there are any questions about any items contained in these instructions,
call the local dormakaba USA, Inc. distributor for assistance.
ESA500 DL0741-050 05-2022 5
ESA500 Fixed Sidelite/All Glass Automatic Sliding Door
Owner's Manual
What You Should Know
Be sure that a dormakaba distributor has provided the following for each door.
1. Instruction on how to conduct the Daily Safety Check (by walk-through example).
2. Location of function switches and instruction in their use.
3. Circuit breaker or power disconnect location for each door system.
4. Discussion of problems that could result from door being allowed to operate after a
malfunction is observed.
5. Number to call for service or questions about your system if you are uncertain of any
condition or situation.
Note: If there are any problems, discontinue door operation immediately and secure the
door in a safe manner. Call your local authorized dormakaba distributor for repair.
6 ESA500 DL0741-050 05-2022
ESA500 Fixed Sidelite/All Glass Automatic Sliding Door
Owner's Manual
Daily Safety Check
Perform these safety checks daily on each automatic sliding door to ensure your customers safety
and your own protection. Perform these tests while traffic is restricted from all detection and sensing
zones.
Motion Detector Actuation
1. Check electronic sensor by walking toward the door
opening at a moderate speed. Door should start opening
when you enter the motion zone and should slide open
smoothly, then stop without impact. Repeat on other side
of opening. Move slowly through the door. The door should
remain open. (See Figure 1)
NOTE: If your door is set-up for one-way traffic, the
detector on the side not intended for use should be active
until the door is within 6 inches of fully closed. The sensor
Figure 1 should reopen the closing door if an object is detected a
minimum of 24 inches from the door.
2. Step out of the sensor zone. After a brief time delay (at
least 1-1/2 seconds) the door should slide closed smoothly
and close fully without impact. Doors should be adjusted
so they do not close faster than 1 foot per second.
3. Observe traffic routing to door. Plan traffic routing so
persons will approach the door straight on and not from an
angle.
4. Walk parallel to the face of the door and check that the
Figure 2 detection pattern is at least as wide as the door opening.
This test should be performed about 2-1/2 feet from the
door face.
5. Open the door. Cover each doorway holding beam (if applicable)
with your hand and stand motionless for several seconds. (See
Figure 2). The door should remain open. Remove your
hand and the door should close after the delay expires. If
other safety devices are being used, stand motionless in
the door opening for 10 seconds. The door should not
close. (See Figure 3)
Floor Mat Actuation
Figure 3
6. Step on the "opening" mat in several places. Door should
slide open smoothly and stop without impact. (See Figure
4).
7. Step through the doorway onto the mat on the other side.
Door should remain fully open without interruption.
NOTE:
If there is more than one mat on each side, each
mat should be tested.
8. Check the mat molding and threshold. It should be
complete and secured with all screws required.
Figure 4 9. Step off the mat. After a brief time delay (at least 1-1/2
seconds), the door should close slowly and smoothly
without impact. Doors should be adjusted so they do not
close faster than 1 foot per second.
ESA500 DL0741-050 05-2022 7
ESA500 Fixed Sidelite/All Glass Automatic Sliding Door
Owner's Manual
General Safety
Disconnect the appliance before servicing.
Decals
Door should have decals properly displayed. Each leaf
should have a decal that includes the statements:
"AUTOMATIC DOOR" with an arrow (See Figure 1)
should be visible from each side of Door, OR
If the door is designed for one-way traffic, the door should
Figure 1 have an arrow on the egress side and " DO NOT ENTER"
on the controlled traffic side of door. (See Figure 2)
Each sidelite should have a decal visible from the sliding
leaf side of the door that reads "STAND CLEAR
AUTOMATIC SLIDING DOOR" (See Figure3) This decal
is not required on fully pocketed door.
DO NOT
Closing Speed
Sliding doors must be adjusted to comply with ANSI
A156.10 - 2005.
ENTER
The operator and the ES-A control-board are self-learning
Figure 2 and self-monitored. All necessary adjustments in
accordance to ANSI A156.10 are made automatically
during the initial self-learning cycle of the operator.
No manual adjustments are necessary.
AUTOMATIC SLIDING DOORPEN
Figure 3
AUTOMATIC SLIDING DOOR AUTOMATIC SLIDING DOOR
IN EMERGENCY PUSH TO OPEN IN EMERGENCY PUSH TO OPEN
Decal Decal
Centered on Centered on
the Door at the Door at
36”-60” Approximately
Above Finished 58" (1473 mm)
Floor Above Finished
Floor
8 ESA500 DL0741-050 05-2022
ESA500 Fixed Sidelite/All Glass Automatic Sliding Door
Owner's Manual
This page left intentionally blank.
ESA500 DL0741-050 05-2022 9
dormakaba USA, Inc.
1 Dorma Drive, Drawer AC
Reamstown, PA 17567
USA
T: 717-336-3881
www.dormakaba.us F: 717-336-2106
