Scribd
Upload
126 views

ABS Basic Setting

The document provides instructions for calibrating sensors in the ABS system, including the steering angle sensor and ESP sensor unit. It instructs to select the ABS option from the main menu, clear any fault codes, enter the security code, select the basic settings option for the relevant sensor group, and check that the sensor readings and fault codes are within specifications after completing the calibration process.

Uploaded by

Siya Booi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
126 views

ABS Basic Setting

The document provides instructions for calibrating sensors in the ABS system, including the steering angle sensor and ESP sensor unit. It instructs to select the ABS option from the main menu, clear any fault codes, enter the security code, select the basic settings option for the relevant sensor group, and check that the sensor readings and fault codes are within specifications after completing the calibration process.

Uploaded by

Siya Booi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

ABS Basic Setting

Sensor for Steering Angle (G85)


[Select]
[03 - ABS Brakes]
[Fault Codes - 02]
[Done, Go Back]
Start Engine (session still running).
Turn steering wheel at least 30 ° left and back straight ahead.
[Meas. Blocks - 08]
Group 005 Field 1 (Steering Angle Sensor -G85-)
Specification: 0.0 °
Tolerance (when straight): ±5.0 °
[Done, Go Back]
[Security Access - 16]
Enter 40168
[Do It!]
[Basic Settings - 04]
Group 001
[Go!]
[Done, Go Back]
[Fault Codes - 02]
All fault codes should have disappeared.
[Done, Go Back]
[Close Controller, Go Back - 06]

ESP-Sensor Unit (G419)


[Select]
[03 - ABS Brakes]
[Security Access - 16]
Enter 40168
[Do It!]
[Basic Settings - 04]
Group 069
[Go!]
Field 2 should show OK after a successful Calibration.
[Done, Go Back]
[Meas. Blocks - 08]
Group 010 Field 1/2 (Longitudinal Acceleration Sensor (G251))
Specification: ±1.25 m/s²
[Done, Go Back]

[Fault Codes - 02]


All fault codes should have disappeared.
[Done, Go Back]
[Close Controller, Go Back - 06]

You might also like