GPS TIME SYNCHRONIZATION EQUIPMENT

Syntime - 9905

Features Applications
n GPS Time and Frequency reference n SCADA
n Built in NCO, OCXO and TCXO provides redundancy n Energy Management System
n 2048 KHz, E1 output for communication Networks n Dynamic Demand Management System
n Time signals in IRIG B/E, RS-232, MODBUS (RS-485) n Energy Meters - HT Consumers & Feeders
n 10 / 100 MBPS NTP and SNTP output n ABT / Boundary meters
n Sleek and small 1U footprint n Disturbance Recorders
n Isolated and protected interfaces n Event Loggers
n Fibre Optic outputs n Load Dispatch Centre
n Large size Remote Display Unit

Technical Specifications: Syntime - 9905

Antenna User Interface
n Configuration : Single (Standard) n LCD Display : 20 x 2 Alphanumeric
: Dual redundant (Optional) n Status LEDs : 4- GPS, NTP, RTC, Power
n Antenna Type : Active n Keys : 3-Up, Down and Enter
n Gain : 35±3 dB n Alarm contacts : SPST- 125 VAC, 0.3A
n Coverage : 360º Azimuth: 0 to 90º Elevation
n Operating temp : -40 to +85ºC
Computer Interface
n Environmental : All weather water proof
n RS-232 : 2 Nos front panel
n USB : 2 Nos front panel
GPS Receiver
n Configuration : Single (Standard)
Pulse Signals
: Dual redundant (Optional)
n Pulse Per Second : 1 x 250 V, 0.2 A, SPST-
: 1 x Remote GPS input : PFC Solid state relay
(Required for antenna cable length : 1x Isolated TTL
greater than 20 mtrs. Optional and n Accuracy : 20 ns rms
installation specific) n Pulse width : 230 mS
(Factory set-100 mS to 500 mS)
n Outputs : PPS, Time, Position & Frequency
n Pulse out puts : 4-PPM, PPHH, PPH, and PPD
n Satellite Tracking : 12 Channels, C/A code (all 4 ports can be field configured
n Acquisition Time : Cold < 45s for any pulse)
: Warm < 38s n Connector : Euroterminal, Twistedpair
: Hot < 5s
: Re acquisition <0.5s Time Code Signals
n IRIGB : AM & PWM
External Clock input (Optional) n Connector : 75E coax for both
n Frequency : 1- 20MHz (Factory set) (IRIG E instead of IRIG B Optional)
: Coax 75E
n E1 clock : 2048 Khz, HDB3 coding Serial Time signals
: Coax 75E or TP-120E n Modbus on RS-485 : 1 x Broadcast mode
(Not available when using remote GPS input) n Connector : Euroterminal or DB9
n Content : Time, position, status (customisable)
Event Input (RS-232 instead of RS-485-optional)
n External : Isolated, TTL/ 5V CMOS n Ethernet Port : 2 x 10/100Mbps
n Connector : Euro terminal, two wire n Connector : RJ45
n Protocol : SNTP / NTP (one port each used for
SNTP and NTP)

ISO 9001:2008 Certified Company

www.sandsindia.com
 Front View

Rear View

Optical Ports Compliance

n No of Ports : 1 x PPM, 1 x IRIGB PWM n Safety : IEC 60950
n Type : IR LED 820 nm n ESD : IEC 61000-4-2,Contact ±4KV
n Connector : SC simplex : (Lvl 2); Air ± 8KV(Lvl 3)
n Fiber : 62.5/125um, Graded n Radiated Immunity : IEC 61000-4-3; 3V/m,
n Range : up to 1500mtrs : 80 MHz to 1000 MHz. (Lvl 2)
n Radiated Emission: EN55022 Class A
n EFT : IEC 61000-4-4; 1KV (Lvl 2)
Mechanical n Cold : IEC 60068-2-1; -25±3°C, 72Hrs
n Enclosure : 1U, 19” rack mountable n Dry Heat : IEC 60068-2-2; +70 ±2°C, 72 Hrs
: Rear entry, customizable back panel n Shock Test : IEC 60255-21-2;
n Size : 44 H x 443 W x 270 D mm : 30g, Half sine,11ms-3 x 6 Shocks
n Weight : 5Kg (Max) n Damp heat : IEC 60068-2-30;+40±2°C, 2cycles
n compliance : IP20 (48Hrs-Off Condition)
n Vibration : IEC60068-2-6 ; 10-150-10 Sweep,
Power Supply : 4 mm P to P/2.2g, 1 octave/min,1hr
n Standard : AC 90 to 260V, 47-63Hz or DC 130V to 370V : Each in 3 axis and both directions
n Custom : 110V DC, 48V DC, 24V DC or any other Standard Accessories:
(Custom requirements need to be confirmed) n Antenna
n Power : 30 W Mounting assy : 1 for each antenna
n Reliability : 215000 Hrs (min.) n Power Cord : 1(2mts)
n Compliance : EN55022 Class A n Mating connectors : 1 set
n Software : 1 CD
n Documents : User manual, test reports
BCS Software
n Configuration (Cables and connectors extra as per installation requirements)
Software : Windows based
Optional Accessories
Environmental n Remote Receiver
n Operating Temp. : 0 to 55 deg C n IRIG B AM Hub
n Humidity : 10-90% Non Condensing n IRIG B PWM Hub
n RS-485 Hub
n RS-485 to RS-232 converter

300 mm Display
DS
SAN

Remote
Display Unit

100 mm Display
DS
SAN

Remote Display Unit

MF-7, CIPET Hostel Road, Thiru.Vi.Ka. Industrial Estate, Ekkaduthangal,Chennai - 600 032.
Tel : (044) 2225 3832 / 33 / 34, Fax: (044) 2225 3831,
Centre: 15/D-19, IT Park, SIPCOT, Siruseri - 603 103.
e-mail: [email protected].
Product developement is continuous process - Specification subject to change
EDITION : 03-12’
www.sandsindia.com