Scribd
Upload
140 views1 page

MIM-B14 - MIM-B14 - External Contact Control Installation Manual

The document provides instructions for installing an external controller for an indoor unit. It includes a list of parts needed, installation steps, and a diagram showing how to connect the external controller to the indoor unit PCB. Indoor unit installation option settings are also discussed.

Uploaded by

Joshua Cuevas
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
140 views1 page

MIM-B14 - MIM-B14 - External Contact Control Installation Manual

The document provides instructions for installing an external controller for an indoor unit. It includes a list of parts needed, installation steps, and a diagram showing how to connect the external controller to the indoor unit PCB. Indoor unit installation option settings are also discussed.

Uploaded by

Joshua Cuevas
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

EXTERNAL CONTROLLER INSTALLATION DB98-26202A-03

Parts Indoor unit without DIP S/W

PRODUCT EXTERNAL Purpose 5, 6 INPUT 3, 4 OUTPUT 1, 2 OUTPUT


PCB CASE HARNESS WIRES SCREW
NAME CONTROLLER
Turn on/off the indoor unit via THERMO ON/OFF or
DRY CONTACT
QUANTITY 1EA 1EA 1EA for EACH WIRE 2EA external contact control OPERATION ON/OFF
ERROR STATUS
Control external heater External heater’s Switch
(Normal Close)
Turn on/off the indoor unit via
external contact control and DRY CONTACT External heater’s Switch
control external heater(1*)
SHAPE
(*1) When the purpose is to use as external heater’s on/off signal, monitoring signal for external contact control will not
be outputted.

Circuit diagram of external controller’s output


For turning on/off the indoor unit via external contact control
Installation
1. Fix PCB case( ) inside the indoor unit control box or at an appropriate position with screws ( ). AC LAMP

2. After fixing PCB cases, attach the external controller PCB. (See the following figure, Assembly Drawing)

[figure, Assembly Drawing] WIRE

SCREW PCB CASE


WIRE

SCREW fixing
Positions

Screw fixing positions


when necessary
Align the case locking with the PCB locking

For controlling external heater (On/Off)


3. Connect 2 pin wire ( ) between the external controller PCB CN83 and indoor unit PCB EXT_CTRL connector(CN83).
Circuit diagram for using external heater for the indoor units without hot water coil terminal
4. Connect 4 pin wire ( ) between the external controller PCB CN81 and indoor unit PCB COMP/ERROR
connector(CN81). Detailed method about Installation option establishment
refers to Indoor Unit manual. (External contact control
Installation option setting of indoor unit setting: Refer to SGE14, SGE15 of 02 Series installation
AC option External heater control setting: Refer to SEG15
of 02 Series Installation Option and SEG18 of 05 Series
Indoor unit with DIP S/W Relay External installation option))
Operation Specification according to Indoor Unit PCB installation option Set up Heater
Dry contact(no power source contact) must be be
connected to the input terminal 5,6.
OUTPUT STATE
WIRE NO. When MIM-B14 is used for controlling external heater, its
K11 OFF K11 & K12 OFF
contact should not be connected directly to the load.
1,2 Error Check (Only use as switch as shown in above diagram.)
3,4 COMP. Check Operating Check
5,6 Signal Input (TIMER)

English

SOL MIM-B14 IM-EN,TR_DB98-26202A-03_A5.indd 22-23 2016-06-20 오후 7:48:40

You might also like