Scribd
Upload
34 views2 pages

731 3R e

Uploaded by

Mohammedasif
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
34 views2 pages

731 3R e

Uploaded by

Mohammedasif
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 2
SULZERTEX7/L. G 6200. Adjustment Instructions Selvedge cutter F Mounting the selvedge cutter ‘After weaving start up, the selvedge cutters have to be set into the gap between the selvedge and the auxiliary selvadge. Adjust the pasition of the selvedge cutter vertically and horizontally according to the fabric. Make sure that pin 2 with bush 3 is located in the guide slot. Moving machine parts! Danger of injury to fingers = For weaving operation protective cover 1 always installed. With the machine running, check if the lower blade is allowed to move freely. Setting of pretension The pre-tension is set as low as possible by turning of spring tensioner 6. Loosen nut 7 slightly. Put a small allen wrench or a pin into the hole of spring tensicner 6 and turn it clockwise (higher pre tension) or counter-clockwise (lower pre tension) Tighten nut 7, 6200 © 20.7.96 731.3R Page 1 SULZERTEX7/L. G 6200____ Positioning of the selvedge cutter Horizontal setting Loosen screw 4 The selvedge cutter has to be positioned on the cylin der pin in such a way that weft ends protrude 2..3 mm from the selvedge. Tighten screw 4 Setting of cutter height and opening Open selvedge cutter fully. Loosen screw 4, Position the cutter so that the fabric runs into the utter with a 2 mm distance to the fixed blade. At the same time the distance between cutter blade lever 5 and precision pin has to be at least 0.5 mm. For this, screw 9 may possibly have to be loosened also. Tighten screws 4 and 9. 731.3R Page 2 6200 © 20.796

You might also like