English

SPECIFICATIONS
Thank you for choosing Nevoks product. Please read the instruction carefully before
use. If there is any additional requirement about the product, please consult the
Pod Parameters
local agent or contact us through our website: www.nevoks.com Capacity 2.2ml
Pod Material PCTG
EXPLODED VIEW Resistance
0.6Ω Kanthal（SPL-10 Mesh Coil）
Drip tip 1.0Ω Kanthal（SPL-10 Mesh Coil）

PAGEE POD KIT Cartridge

Refill Port
Device Parameters
Material Zinc Alloy
User Manual SPL10 Coil Button "+" / ''-''
Weight 70g
Output Wattage 5W-30W
LED Screen Screen Size 0.69inch
Input Voltage 3.3~4.2V
Fire/Mode Button Battery Capacity 950mAh
Size 77.6*44.6*12.6mm
Type-C Port
Charging Type C 5V/2A
Adjustable Airflow Charging Time Around 50 minutes
www.nevoks.com Maximum Vaping Duration 10 seconds
Shenzhen Nevoks Technology Co., Ltd. 1 2

PACKING LIST Interface introduction 2.Start Vaping

Pagee Device X1 Type-C Cable X1 Pressing the firing button or just inhaling both can give you the extremely
Pagee Empty Pod(2.2ml) X1 User Manual X1 Mode Resistance smooth vaping experience. The auto-draw function and firing button could
SPL-10 Mesh Coil 0.6Ω X1 Warranty Card X1 be switched freely and no button pressing. (If the auto draw is not very
SPL-10 Mesh Coil 1.0Ω X1 Power Battery level sensitive, press the fire button 3 times continuously to close the auto-draw,
there is a letter M on the screen)
USE INSTRUCTION Puffs
3.Power adjustment
Operations steps
Pagee use the intelligent SPL coils, please kindly notice the suggested
1.Install the Coil Function description wattage before vaping.
Take out the coil, and insert the coil from the bottom of the pod. 1. Power on/off the Device
2.Replace the Coil 1. Click the power button 5 times in 2 seconds to power on or power off.

------

------
2.1Please confirm the pod is empty before replacing coil. SPL 10 Coils SPL10*0.6Ω Mesh SPL10*1.0Ω Mesh
When power on, the LED screen will show the current wattage, voltage, ---------------------------------------------------------------
2.2Pull out the used coil Suggested Power 18-25W 10-13W
power status, resistance and so on. The LED screen will be off if without any
2.3Install a new coil firmly
3.Fill the E-liquid operation in 20 seconds.When power off, the letter Bye will be showed then 4.Charging the Battery
-Uncover the silicone plug at the side of pod. the screen will be off. After connecting the Type-C(5V/2A) cable to the device, the sign of the
-Gently insert the e-liquid filling bottle tip to the filling slot and press down to 2. Lock/Unlock: Press the fire button and up&down button at the same time, battery will flash, and the power charging percentage will be showed on the
squeeze the e-liquid through the slot. there will be a letter P on the screen, then your device will be locked at this screen. Once fully charged, the sign of the battery and power percentage
-Please wait for 5 minutes for the e-liquid to soak into the coil. time. Repeat the instruction, unlock the device. will reach 100%.
3 4 5

5.Settings
CAUTIONS
PROTECTIONS
Puff resetting: Under the power off status, pressing the fire button and the *Please turn off the device when it is not in use.
wattage key at the same time, the LED screen will show the date like this 1. No Load Protection: When the device cannot detect the coils, the device *Do not leave the charging device unattended.
20201027 which depends on the version, this means the current puffs have will stop working and show “NO ATOMIZER” on the screen. *Do not drop, throw or abuse your device, which may cause damage.
2. Overtime Protection: The LED screen will show “TIME OUT” to avoid the *Keep away from the water or any flammable gas, liquid.
been cleared and the puffs will start from 0001.
atomizer's coil and cotton being burned. *Do not expose the device to direct sunlight, dust, moisture or mechanical
2. Wattage adjustment: Just pressing the wattage key to adjust the 3. Short-circuit Protection: The LED screen will show “SHORT” when the shock.
wattage, the wattage will be showed from minimum 5W to maximum 30W by short-circuit or low resistance is detected. *Do not expose the device to extreme temperature.
cycling. 4. Low Voltage Protection: When the output is below 3.3V, the sign of the *Battery recycling: The product battery should not be treated as household
battery will be blank and flash, the device won’t work. If press the fire waste, instead, it should be handed over to the applicable used battery
3. Airflow adjustment: 360° rotating the lid at the bottom of the device to
button at this moment, the LED screen will show “LOW VOLT”. collection point for recycling.
adjust the airflow.
5. Over-temperature Protection: If the temperature is over 65℃ before
4. Dormant state: The screen will be off if without any operation for 20 firing, and over 85℃ during the firing, the LED screen will show “TOO HOT”.
seconds, press any key to wake up. 6. Over charge Protection: When the battery is fully charged, the device will WARNINGS
stop charging and show “100%” on the screen. This refillable electronic cigarette is intended for use with compatible e
5. Auto-draw on/off: When the Interface shows M, it means Auto-draw off.
7. Over discharge Protection: When the voltage drops to a low value, the
Click the power button 3 times in 2 seconds to Auto-draw on or Auto-draw -liquid, which may contain nicotine. Nicotine is an addictive substance and
device will stop working.
off. it is not suitable or recommended to use in following cases:
6 7 8

3. You may experience the following results if you use nicotine containing
1. This device is not suitable for:
e-liquid with this product. If it happens, please consult a healthcare
*Persons under the legal smoking age.
professional and show them this leaflet if possible:
*Persons experiencing heart disease, stomach or duodenal ulcers, liver or
*Feel faint-Nausea-Dizziness-Headache-Coughing-Irritation of the mouth
kidney problems, long-term throat disease or dif f iculty breathing due to or throat
bronchitis, emphysema or asthma. *Stomach discomfort –Hiccups-Nasal congestion-Vomition
*Chest palpitation/pain or an irregular heart rate
*Persons with an overactive thyroid gland or experiencing phaeochromocy-

toma (a tumor of the adrenal gland that can affect blood pressure).

*Persons taking certain medications like Theophylline, Ropinirole or

Clozapine and etc.

2. This device is not recommended for:
*Non-smokers This device should not be used by persons under
*Pregnant or breastfeeding women. the legal smoking age.
nevokstech nevoks_offcial nevoksofficial
9 10