SIPART PS2 6DR5xxx-xx ATTENTION: See Operating

Leaflet "Operation - a concise overview" Instructions for safety instructions !

Configuring Possible messages
(Order No. A5E00074611-02)
1 Input: supply air PZ
View of device (cover open) 2 Output: Positioning Display Meaning Measures
14 3 pressure Y1
90o 3 Display
15
4 Output: Positioning Acknowledge message
)
pressure Y2 *
2W 3/4W 90° 5 Input keys Actuator does using

33 O
2 6 Restrictor Y1
2 2 ) (simultaneously) (simultaneously) not move
18 ... 6.1 Restrictor Y1 *
3 30V 3 Check restrictor (6) and open
4 4 6.2 Restrictor Y2 *)
5 5 7 Transmission ratio if necessary
selector
6 6 Drive actuator to working

4 ... 20mA
1
13 7 7 8 Sound absorber
8 range using

0/4 ... 20mA

8 9 Adjustment wheel
9 9

O
BE1 for slipping clutch

90
10 10
10 Terminals for basic Restart initialization
up to
unit
o 4 11
33
33° Terminals for option (simultaneously) (simultaneously)
modules Change gearing (7)
12 Plug
12 13 Cable glant Down tolerance
14 Label >5s Continue using
(on module cover)
band violated
15 Purging air selector
6.1 6.2 or adjust sliding clutch up
11 10 9 7 8 6 5 to display
*) With double-action actuators

Changing the input level Automatic initial start-up (starting with factory setting)
Mode Display Step Meaning then only
Continue using
1.)
P-manual mode Potentiometer Part-turn Linear actuator:
setting [%] actuator Once the slipping Set pick-up lever into vertical
Change position clutch has been
using position using
Not initialized
adjusted
Linear actuator
(can be reached Continue using
using preset)
Acknowledge message

PRST
Configure >5s Press for > 5 s using
Parameter
Change parameter value
2.) Up tolerance band Set the next highest travel
Remaining steps carried out automatically
name using violated value on the lever
Parameter
number Restart initialization
Change value >5s
Parameter Additionally possible with rotary
using
name actuators:
3.) Direction of action is determined
>5s >5s
Manual mode Adjust using up to
Position [%]
display:
Checking of travel and adjustment
Change position Error code 4.) of zero and stroke
using (from stop to stop)
Mode and
>5s
Setpoint [%] Determination and Display of positioning Continue using
5.) time down (dxx.x), up (uxx.x) Stop with
1x 1x Acknowledge message
Automatic Position [%] Pressing the key initiates leakage measurement
Up/down span using
violated Set the next lowest travel
Error code Determination of minimum value on the lever
6.) increment length
Mode and Restart initialization
Setpoint [%]
+ + Adjust positioning time using
Actuator does
Diagnosis >2s >2s restrictor(s)
Diagnosis 7.) Optimization of transient response not move
value Positioning Continue using or
+ + time is possible
>2s Initialization terminated successfully to adjust
Diagnosis (travel in mm for linear actuators)
number 8.) (angle of rotation for part-turn
(The gray values in the top display line are examples)

Diagnosis name actuators) Continue using: See Manual for further messages