Scribd
Upload
54 views

ECE3110Fa10 HW2sol

Uploaded by

楊明倫
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
54 views

ECE3110Fa10 HW2sol

Uploaded by

楊明倫
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Homework #2

1. Consider a traditional BJT current mirror with a nominal current transfer ratio of unity.( eg Io/Iref=1)
IS=10-15 A, β=100, and VA=100V. For IREF=1mA, find IO when Vo=5V. Also, find the output resistance.

2. Assuming the availability of BJTs with scale currents IS=10-15 A, β=100, and VA=50V, design the
current-source
source circuit of the figure below to provide an output current Io=0.5mA at VO=2V. Use a power
supply VCC=5V. Give the values of IREF, R, and VOMIN. Also, find the actual value of IO at VO=5V.

For Vo=5V:

3. Find the output resistance of each of the two current sources below. Let
R1=942kΩ, R2=9.3kΩ, R3=11.5kΩ, VA=100V and β=100.

For (a)
For (b)

Fall 2010 1
Homework #2
source circuit of the figure below utilizes a pair of matched pnp transistors having IS=10-15
4. The current-source
A, β=100, and VA=50V. It is required to design the circuit to provide an output current Io=1mA at Vo=2V.
What values of IREF and R are needed? What is the maximum allowed
value of VO while the current source continues to operate properly? What
change occurs in corresponding Io to VO changing from the maximum
positive value to -5V?

Fall 2010 2
Homework #2
5. Find the voltages at all nodes and the currents through all branches in the circuit below. Assume
|VBE|=0.7V and β=∞. (worth 3 problems)

Fall 2010 3
Homework #2
6. For the circuit below, let |VBE|=0.7V and β=∞. Find I, V1, V2, V3, V4, and V5 for (a) R=10kΩ and (b)
R=100kΩ. (worth 2 problems)

Fall 2010 4
Homework #2
7. Using the ideas embodied in the figure below, design a multiple-mirror circuit using IREF=0.2mA and
power supplies of ±5V to create source currents of 0.4mA, and 0.8mA(currents shown below as I1, and
I3) and sink currents of 1mA, and 2mA(currents shown below such as I2, and I4). Assume that the BJTs
have |VBE|=0.7 and large β. What is the total power dissipated in your circuit?

Fall 2010 5

You might also like