Quick Start Guide

to the Solo range of

detector test equipment
solo
detectortesters
TM

Kurzanleitung
für Solo
Melderprüfgeräte

Démarrage rapide
de la gamme Solo
de matériel de test
de détecteurs

Guida rapida per

l'apparecchiatura della
gamma Solo per il
solo
det
ecto
ectort ®TM
rtes
este
ters
rs

colaudo dei rilevatori

ENGLISH

Guía rápida para DEUTSCH

la gama Solo de equipos FRANÇAIS
de comprobación ITALIANO
de detectores ESPAÑOL

Solo Product Range Selector

DE
FR
IT
ES

Solo Testing Kits

Solo Sets
Kits de série Solo
Kit della serie Solo
Kits de la serie Solo

detectortesters
testing technology from No Climb

www.detectortesters.com
Quick Start Guide to the Solo range of detector test equipment
Solo 330 Aerosol Dispenser
If the detector has not Maintenance Excess liquid
5 responded in 10 seconds, deposits may be experienced
repeat the test every 10 seconds. following extended periods of use.
Number of total sprays should To clean, use a lint-free cloth.
not exceed 5. If the detector fails Wash the cup with a mild
to activate, check equipment and detergent in warm water and dry
retest. If the detector does not thoroughly.
1 2 3 4 activate it will require further
investigation.
Unscrew and remove Place aerosol canister Replace retainer cup and Insert the Solo 330 into
retainer cup. into cup. screw upwards. Adjust until Solo pole. Place Solo 330 Tip To prevent the possibility
aerosol activates and unscrew over the detector and press of the aerosol discharging while in
slightly. upwards to activate the transit, loosen the retainer cup by
aerosol (1 second burst). unscrewing 2 full turns.
Solo 332* Aerosol dispenser
available for larger detectors.

Solo A3 Solo C3 Solo A7

Smoke Detector CO Detector Detector
Tester Tester Duster
Designed to be used only Designed to be used only Designed for handheld use only.
with Solo 330 (332*) with Solo 330 (332*) Use a Solo 200 removal tool to
dispenser. dispenser. remove and clean high-mounted
detectors.
IMPORTANT IMPORTANT
Read the instructions and Read the instructions and IMPORTANT
warnings before use and warnings before use and Read the instructions and
dispose of with care, even dispose of with care, even warnings before use and Solo 100
when empty. when empty. dispose of with care, even
when empty.

Solo 100 and Solo 108 Telescopic Access Pole A Solo 101 1.1m extension pole
can extend the Solo 100 and 108
telescopic pole, or may be used by itself
with the Solo range of tools. Solo 101

Caution A maximum of 3 extension

poles is recommended.

Maintenance The Solo poles can be

cleaned with mild detergent or
1 2 3 water and a soft lint-free cloth.

solo
®

Lubrication is not necessary.

rs
este
ctort Extend the Solo pole. Twist to lock button. Insert Solo tool into pole.
dete
Caution When working at height it is recommended
that a competent person carries out a suitable risk assessment. For further information on poles, see
Solo 100: 4 sections
This will identify any risk to the user and/or the environment “Instructions for Solo Poles” document
Solo 108: 2 sections
and hence any need for Personal Protective Equipment (PPE). at: www.solo-tester.com/support

Solo 461 Cordless Heat Detector Tester Solo 760 Battery Baton Charging
The tool will automatically start testing
4 when infra-red beam in cup is broken.
The green LED will flash faster. Hold in place
until the alarm is activated*. When the detector
alarms, remove the tool from the detector.

It will revert to standby mode (slow flashing 1 2 <90min.

green LED), and the internal blower will cool Connect charger to power outlet or Connect battery to charger. LED will flash
1 2 3 the heating element for a few seconds. After vehicle accessory socket using power red/green, then red only to show fast
testing, switch off at red switch to preserve cable supplied or the umbilical DC charging. LED is green only when battery
connecting lead. LED will not is fully charged. If LED flashes red, there
Insert a charged battery Press the red switch to turn Position the latch and place battery baton life. illuminate permanently. is a battery fault.
baton into the tool and pole. on. LED illuminates green. over detector. (*If the detector fails to activate it may be faulty. Insert a Red/Green Flashing Battery Testing
replacement detector and test again) Warning Do not attempt Red Fast Charging
Flash at slow rate indicates to use or charge the battery
Green
Red Flashing
Ready for Use
Battery Fault

Caution Ensure correct normal STANDBY mode. Tip Ensure the baton if either the charger
detector rests Caution unit or the battery baton
orientation when inserting Remove battery baton when not in use. Tip: Ideally, fully discharge battery
firmly on connection point are damaged.
battery baton into tool and do baton in normal use before
not use undue force to insert. platform. recharging.

Solo 423/4 Heat Detector Tester SAFETY INFORMATION

If detector does not
4 activate within 1 minute
it may be faulty.

Solo 423 (110v)

Solo 424 (230v)

1 2 3 Fitted with a thermal cut-out

DO NOT TOUCH DO NOT BLOCK AIR NO USER SERVICEABLE
protection system. METAL GRID. VENTS. PARTS.
Attach power cable, secure Insert the tool into Solo Connect to power and press
clip, and if required, add pole. ON switch. Place over
optional extension cable. detector.

Solo 200 Universal Removal Tool

1
Pull and twist the Tri-grips
to adjust for different
detector sizes.
2
When inserting into a Solo
pole, locate lower button for
access to detectors at angles.
3
When inserting into a Solo
pole, locate upper button for
use vertically.
4
Grip detector, twist and
pull down to remove. solo
detectortesters
TM
Solo Product Range Selector

Solo™ Smoke Heat CO Access Solo 200 Solo 610 Solo 760 Solo 726
Testing* Testing Testing** Height Removal Carrying Battery Battery
Model No. (approx. max.) Tool Bag Baton Charger
normal
808 ceiling
height
normal
809 ceiling
height
normal
810 ceiling
height

811 6.0m
Kits

812 8.2m

814 6.0m

822 6.0m *Using Solo A3 Smoke Detector

Tester Aerosol

823 9.0m **Using Solo C3 CO Detector

Tester Aerosol

Solo™ Product Description

Model No.

A3 Smoke Test Aerosol Canister (for use with Solo 330 Dispenser)

C3 CO Test Aerosol Canister (for use with Solo 330 Dispenser)

A7 Detector Duster Canister (for handheld use only - for access, remove detectors at height with Solo 200)

100 Telescopic Access Pole From 1.26m to 4.50m in 4 sections for access up to approx. 6.00m
Individual Components

101 Extension Pole 1.13m length

108 Telescopic Access Pole From 1.20m to 2.20m in 2 sections for access up to approx. 3.70m

200 Removal Tool For detectors of 65mm diameter up to 110mm diameter

330 Smoke Dispenser For testing detectors of up to 100mm in diameter

332 Smoke Dispenser For testing detectors of up to 133mm in diameter

423 Heat Tester Mains Powered 110V AC

424 Heat Tester Mains Powered 220V AC

461 Heat Tester (Kit) Cordless Heat Tester (inc. 2 x Solo 760 Battery Batons & 1x Solo 726 Battery Charger)

610 Carrying Bag For carrying Solo Head Units, Battery Batons, Charger & Aerosol Cans

solo
detectortesters
TM
Solo Testing Kits
Solo Sets
Kits de série Solo
Kit della serie Solo
Kits de la serie Solo

lo
so
ers
est
ort
ect
det

lo solo
®

so
ers ers
est ortest
rt detect
cto
te
de

®
lo
ers
est
so
ort
ect
det
lo
s
er
st
rte
so
cto
te
de
o
®

sol
dete
ctor
test
ers

solo
detec
torte
sters

solo
s
ester
ctort
dete

Solo 810 Solo 811 Solo 812

solo
®

lo
®

lo
ers
ortest

so so
rs rs detect
te te
rtes rtes
to
ec cto
det te
de
®
lo

lo

solo
®
rs

rs
ste

ste

solo ters
rte

rte
so

tortes
so

sters
detec

solo
cto

cto

torte rs

detec
orteste
te

te

detect
de

de

solo
detect
orteste
rs

solo
detect
orteste
rs

®
lo
ers
est
so
ort
ect
det
Solo 814 Solo 822 Solo 823

solo
dete
ctor
TM

teste
rs

As our policy is one of continuous improvement, details of products

described within this publication are subject to change without
notice. All information provided here is believed to be correct at the
time of going to press. Every effort has been made to ensure the
accuracy of information which is provided in good faith but nothing
detectortesters testing technology from No Climb
contained herein is intended to incorporate any representation or
warranty, either express or implied or to form the basis of any legal
relations between the parties hereto, additional to or in lieu of such
as may be applicable to a contract of sale or purchase.
No Climb Products Ltd
Edison House
163 Dixons Hill Road
Welham Green
Hertfordshire AL9 7JE
United Kingdom

Tel: +44 (0) 1707 282 760

www.detectortesters.com
Fax: +44 (0) 1707 282 777

[email protected] L132345-1