HYYP IP Connect With WiFi
HYYP IP Connect With WiFi
Introduction
The IDS HYYP IP Connect Module is a plug on module for the X-Series alarm panels. The HYYP
IP Connect Module will enable your X-Series panel to communicate with the HYYP platform
allowing it to report to your HYYP Base Station (monthly charges apply) and the HYYP Home
mobile app.
1. Installation
1.1. Wiring
Connect the HYYP IP Connect Module 12v input to the TX connectors of the X-Series panel. Be
sure to connect the 12V to positive and GND to Negative.
Connect the provided serial cable from the serial connector on the X-series panel to the serial
connector on the HYYP IP Connect Module.
Tip: The red wire on the X-Series panel should be closest to the panel’s heat sink.
To use WPS simply power the IP Connect with the WiFi Module
and when the Panel Comms, Network Comms and Server Auth
LEDS start flashing one at a time in a clockwise sequence press
the WPS button on your router.
1.3. Programming
Location 196 is needed if you want to use the HYYP Home app, reporting should still work
without location 196 programmed.
Once installed open the HYYP Home App, the first time you open the app you will be asked to
sign up, or login if you have already registered.
Once registered you will be given a HYYP ID and asked if you have a HYYP IP Connect to
connect. Click ‘I have a new HYYP Hub’.
Click ‘Continue’.
Enter the HYYP IP Connects Unique ID number or scan
the unique barcode on the HYYP IP Connect.
Click ‘Continue’.
Click ‘Next’.
Your HYYP Serial has successfully been synced with the HYYP
Home app.
3. Troubleshooting
3.1. LEDs
The HYYP IP Connect Module has 4 LEDs that you can use to view its status.
Power LED – On when the HYYP IP Connect Module has sufficient power.
Panel Comms LED – Flashes when communicating with the X-Series Panel.
Network Comms LED – Flashes when communicating on the network.
Server Auth LED – On when connected to the HYYP platform.
On power up the Network Comms and Server Auth LEDs will flash together, and once it has
made a successful connection to the HYYP platform the Server Auth LED will stay on and the
Network Comms LED will flash when it’s communicating on the network.
If the Server Auth and Network Comms LEDs continue to flash the same number then there is
an error on the HYYP IP Connect Module. You can determine the error by the amount of times
the LEDs flash.