Scribd
Upload
121 views

200 301 Questions

Uploaded by

maheeer618
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
121 views

200 301 Questions

Uploaded by

maheeer618
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Cisco

200-301 Exam
Cisco Certified Network Associate
Questions & Answers
Demo
Questions & Answers PDF Page 2

Version: 53.0

Topic 1, Exam Pool A

Question: 1

Which command entered on a switch configured with Rapid PVST* listens and learns for a specific time
period?

A. switch(config)#spanning-tree vlan 1 max-age 6


B. switch(config)#spanning-tree vlan 1 hello-time 10
C. switch(config)#spanning-tree vlan 1 priority 4096
D. switch(config)#spanning-tree vlan 1 forward-time 20

Answer: D
Explanation:

Forward time : Determines how long each of the listening and learning states last before the port begins
forwarding.
Switch(config)# [ no ] spanning-tree vlan vlan_ID forward-time forward_time
Configures the forward time of a VLAN. The forward_time value can be from 4 to 30 seconds.
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/12-2/15-
02SG/configuration/guide/config/spantree.html#56177

Question: 2

Refer to Exhibit.
Questions & Answers PDF Page 3

Refer to the exhibit. All routers in the network are configured R2 must be the DR. After the engineer
connected the devices, R1 was elected as the DR. Which command sequence must be configure on R2 to
Be elected as the DR in the network?

A. Option A
B. Option B
C. Option C
D. Option D

Answer: B
Explanation:

Question: 3
Refer to Exhibit.
Questions & Answers PDF Page 4

Refer to the exhibit Routers R1 and R2 have been configured with their respective LAN interfaces The
two circuits are operational and reachable across WAN Which command set establishes failover
redundancy if the primary circuit goes down?

A. Option A
B. Option B
C. Option C
D. Option D

Answer: B
Explanation:

Question: 4
Refer to Exhibit.
Questions & Answers PDF Page 5

Refer to the exhibit Router R1 Fa0/0 is unable to ping router R3 Fa0'1. Which action must be taken in
router R1 to help resolve the configuration issue?

A. set the default network as 20.20.20.0/24


B. set the default gateway as 20.20.20.2
C. configure a static route with Fa0/1 as the egress interface to reach the 20.20.20.0/24 network
D. configure a static route with 10.10.10.2 as the next hop to reach the 20.20.20.0/24 network

Answer: D
Explanation:

Question: 5

What is a benefit of using a Cisco Wireless LAN Controller?

A. Central AP management requires more complex configurations


B. Unique SSIDs cannot use the same authentication method
C. It supports autonomous and lightweight APs
D. It eliminates the need to configure each access point individually

Answer: D
Explanation:

You might also like