Electromagnetcs - Important Questions From Each Module
Electromagnetcs - Important Questions From Each Module
MODULE 1
10. Derive the equation for curl of a vector field in Cartesian co-ordinate system.
11. A Spherical volume charge distribution is given by
Find the electric field intensity E; i) inside and ii) outside the charge distribution
13. Apply Ampere’s circuital law to the case of an infinitely long coaxial cable
carrying a uniformly distributed total current I. Compute the magnetic field
intensity existing in different parts of the cable.
18. Define vector magnetic potential and show that B A , where B is the
magnetic flux density and A is the vector magnetic potential at any point.
19. State and prove boundary conditions for E and H in accordance with Maxwell’s
equations.
20. State and explain Maxwell’s equations in the integral and differential forms.
21. A Parallel plate capacitor with plate area of 5cm2 and a plate separation of 3mm
has a voltage 50sin103t Volt applied to its plates. Calculate the displacement
current assuming ε = 2ε0.
22. Derive the expression of capacitance of two wire transmission line.
23. Derive continuity equation from fundamental laws.
24. Derive the solution of uniform plane wave in lossy dielectric medium.
25. For a plane wave propagating in a lossy dielectric, derive the expression for
propagation constant.
26. Determine the energy stored in electric field and magnetic field.
MODULE 3
MODULE 4
43. Derive an expression for net outward power flow associated with an electromagnetic
wave, from a surface.
44. Derive standard Transmission line equations.
45. A transmission line of length 0.2 λ and characteristic impedance 100Ω is terminated
with a load impedance of 50+200j . Find input impedance, reflection coefficient at
load end, reflection coefficient at the input end and VSWR.
46. A lossless transmission line has a characteristic impedance of 70Ω and phase constant
of 3 Rad/ m at 100 MHz . Find Inductance per meter and Capacitance per meter of the
transmission line .
47. Derive the equation of input impedance of a transmission line due to line terminated
by a load .
48. Derive the expression of characteristic impedance of transmission line.
49. Derive the expression for propagation constant of transmission line.
50. Explain lossless transmission line and distortion less transmission line.
51. A distortionless line has Zo = 60Ω, a = 20 mNp/m, u = 0.6c, where c is the speed of
light in a vacuum. Find R, L, G, C, and λ at 100 MHz.
MODULE 5
52. Derive the expression for r circles and x circles in Smith chart.
53. Explain the propagation of electromagnetic wave in a rectangular waveguide
54. .For TE10 mode of propagation in a rectangular wave guide, with length 8cm and 6 cm
respectively , find the following when frequency of operation
is 6 GHz .
i. Cut off frequency
ii. Cut off wavelength
iii. Guide wavelength
iv. Phase constant
v. Phase velocity
vi. Group velocity
vii. Wave impedance
55. A rectangular wave guide has a dimension of 3cm x 5cm , and is operating at a
frequency of 10 GHz . Calculate the cutoff wavelength, cutoff frequency, guide
wavelength , phase velocity and group velocity and the wave impedance for TE10
mode.
56. Derive the expression for Electric and magnetic field intensities for TM mode of
propagation of rectangular waveguide.
57. In a rectangular waveguide for which a = 1.5 cm, b = 0.8 cm, σ = 0, μ= μo, and ε = 4εo,
Hx = 2 sin (πx/a) cos ( 3πy/b ) sin (π x 10 11- βz) A/m
Determine
(a) The mode of operation
(b) The cutoff frequency
(c) The phase constant β
(d) The propagation constant γ
(e) The intrinsic wave impedance η.
58. At a frequency of 80 MHz, a lossless transmission line has a characteristic impedance
of 300Ω and a wavelength of 2.5m. Find:
i) L ii) C iii) If the line is terminated with a parallel combination of 200Ω and 5pF,
determine the reflection co-efficient and the standing wave ratio.
59. A 30-m-long lossless transmission line with Zo = 50 Ω operating at 2 MHz is
terminated with a load Z L = 60 + j40 Ω . If u = 0.6c on the line, using smith chart find
(a) The reflection coefficient ᴦ
(b) The standing wave ratio s
(c) The input impedance
. 60. Derive the expression for r circles and x circles in Smith chart.
SOLUTIONS
MODULE 1
14.
MODULE – 3
42.
MODULE – 4
46.
51.
MODULE 5
57.
59.
60.