6FM100D-X

Shenzhen Center Power

12V 100Ah(20hr)
Tech.Co.Ltd,.

Overview
The rechargeable batteries are lead-lead dioxide systems. The dilute sulfuric acid electrolyte is
absorbed by separators and plates and thus immobilized. Should the battery be accidentally
overcharged producing hydrogen and oxygen, special oneway valves allow the gases to escape
thus avoiding excessive pressure build-up. Otherwise, the battery is completely sealed and is,
therefore, maintenance-free, leak proof and usable in any position.

Battery Construction
Component Positive plate Negative plate Container Cover Safety valve Terminal Separator Electrolyte
Raw material Lead dioxide Lead ABS ABS Rubber Copper Fiberglass Sulfuric acid

General Features Battery Specification

Absorbent Glass Mat (AGM) technology for efficient gas
Performance Characteristics
recombination of up to 99% and freedom from
Nominal Voltage 12V
electrolyte maintenance or water adding.
Number of cell 6
Not restricted for air transport-complies with IATA/ICAO
Design Life 10 years
Special Provision A67.
Nominal Capacity 77℉(25℃)
UL-recognized component. 20 hour rate (5.0A, 10.8V) 100Ah
Can be mounted in any orientation. 10 hour rate (9.50A, 10.8V) 95.0Ah
Computer designed lead, calcium tin alloy grid for high 5 hour rate (17.4A, 10.5V) 87.0Ah
power density. 1 hour rate (65.2A, 9.6V) 65.2Ah
Long service life, float or cyclic Internal Resistance
applications. Fully Charged battery 77℉(25℃) 5.0 mOhms
Maintenance-free operation. Self-Discharge
Low self discharge. 3% of capacity declined per month at 20℃(average)
Case and cover available in both standard and flame Operating Temperature Range
retardant ABS. Discharge -20~60℃
Charge -10~60℃
Storage -20~60℃
Dimensions and Weight Max. Discharge Current 77℉(25℃) 900A(5s)
Short Circuit Current 2100A
Length(mm / inch) 330/12.99
Charge Methods: Constant Voltage Charge 77℉(25℃)
Width(mm / inch) 171/6.73 Cycle use 2.30-2.35VPC
Height(mm / inch) 215/8.46 Maximum charging current 30.0A
Total Height(mm / inch) 220/8.66 Temperature compensation -30mV/℃
Approx. Weight(Kg / lbs) 32 /70.5 Standby use 2.23-2.27VPC
* Weight deviation: ± 5% Temperature compensation -20mV/℃

Discharge Constant Current (Amperes at 77oF25oC)

End Point
Volts/Cell 10min 15min 30min 1h 3h 5h 10h 20h
1.60V 220 180 105 65.2 27.6 18.9 9. 75 5.20
1.65V 212 173 101 61.6 27.4 18.2 9. 70 5.15
1.70V 192 159 93.6 60.6 26.9 17.9 9. 65 5.10
1.75V 180 148 90.7 59.6 26.6 17.4 9. 60 5.05
5

1.80V 168 139 88.7 56.5 25.1 17.1 9. 50 5.00

Discharge Constant Power (Watts at 77oF25oC)

End Point
Volts/Cell 10min 15min 30min 45min 1h 2h 3h 5h
264.5
16 1.60V 376 311 194 147 122 69.7 52.3 35.6
1.65V 364 306 183 143 116 66.9 50.7 35.2
5

1.70V 346 290 178 134 112 65.9 50.4 34.8

1.75V 339 285 173 131 109 63.7 48.6 34.2
40

1.80V 316 271 167 128 102 61.7 48.0 33.8

(Note)The above characteristics data are average values

obtained within three charge/discharge cycles not the mimimum
M8 values.All data shall be changed without notice,Vision reserves
the right to explain and update the information contained hereinto.

Shenzhen Center Power Tech.Co.Ltd,. STOCK CODE: 002733 www.vision-batt.com

 6FM100D-X
Shenzhen Center Power
12V 100Ah(20hr)
Tech.Co.Ltd,.

Discharge characteristic (25 OC)

Charged
Volume

Voltage
Current
Constant voltage charging
characteristic (0.25CA,25 ℃)
(%) (XCA) (V)
12.0
140

120 0.25
15.0 Charged Volume
Batteryvoltage(V)

100 0.20
9.50A
26.6A17.4A 80
14.0 Charge Voltage
9.6 0.15
13.0
200A 100A 65.2A 60
0.10
40 12.0

0 20 0.05
1 3 5 10 20 30 60 2 3 5 10 20 11.0 Charging Current
min h 0 0
0 2 4 6 8 10 12 14 16 18 20
Discharge time
Charging time (hours)

Relationship between
Self-discharge characteristic
charging voltage and temperature
(V/12V)

(V/CELL)
(V/4V)
(V/8V)

(V/6V)

100

15.6 10.4 7.8 5.2 2.6 90

Capacity(%)

15.0 10.0 7.5 5.0 2.5 Cyc 80

le U
se
14.4 9.6 7.2 4.8 2.4 70
Stan
dby
13.8 9.2 6.9 4.6 2.3 Use 60

13.2 8.8 6.6 4.4 2.2 50

40
-10 0 10 20 30 40 50 60 0 2 4 6 8 10 12 14 16 18 20
Ambient temperature (℃) Storage time: months

Cycle service life in relation to

Life characteristics of Standby use
120
depth of discharge
120

100
100

80
Capacity(%)

Capacity(%)

80

60
Testing conditions:floating voltage:2.27 to 2.30V Cell 60
100% D.O.D. 50% D.O.D. 30% Depth of discharge
ambient temperature: 25oC(77oF)
40 40

20 20

0 0 200 400 600 800 1000 1200 1400

0 4 6 8
Life(year) Number of cycles(cycles)

Temp erature effects on float life Temperature effects on capacit

15
120

100
C
2.30V/Cell 0.05
10
80 0.1C
Capacity (%)

02. C

60
5
1.0C
40
2.0C

20

0
10 20 30 40 50 -20 -10 0 10 20 30 40 50
Temperature ( ℃) Temperature ( ℃)

Shenzhen Center Power Tech.Co.Ltd,. STOCK CODE: 002733 www.vision-batt.com