Scribd
Upload
57 views

TRA Working On Mud Pumps

The document provides a risk assessment for working on mud pumps. It identifies hazards like high pressure areas, slip/trip hazards, and improper isolation. It rates the hazards and outlines mitigation controls like proper isolation, PTWs, lock out/tag out procedures, and ensuring adequate tools and communication. The residual risks are rated as low.

Uploaded by

elfakeh90
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
57 views

TRA Working On Mud Pumps

The document provides a risk assessment for working on mud pumps. It identifies hazards like high pressure areas, slip/trip hazards, and improper isolation. It rates the hazards and outlines mitigation controls like proper isolation, PTWs, lock out/tag out procedures, and ensuring adequate tools and communication. The residual risks are rated as low.

Uploaded by

elfakeh90
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

TASK RISK ASSESSMENT

AKAKUS OIL OPS Dept / location: No of people involved


TRA-HS-08 A.O.O Elsharara Field All Rig Locations

Activity Brief description of job steps

Working On Mud Pumps Prepare a PTW.


Purge all lines of accumulated pressures.
Prepare the appropriate hand tools and equipment required to do the job.
The crane may be required for lifting.

Hazards identified Hazard effects HE rating PR Mitigation and Hazard controls PPE Resi
HE A/B/C/D/E H/M/L required dual
risk

High pressure area. Slip trip fall hazards C/D H Ensure that the pump is correctly L
Tight work area for hammering and isolated from any power source,
tightening parts. Pressure release A/B M electrical or mechanical.

Pump not isolated properly Hand injury B/C/D M Open the discharge valve and
(mechanical pressure and electrical keep it open. L
isolation) Back injury C/D M Close the intake valve.

Miscommunication between the Check the pressure gauge to


Driller and Team working on the ensure that no pressure remains in
pump (scope of the job). the pump. L

Slippery areas which presents a PTW should be issued prior to any


slip/trip hazards. work being done. Lock out and tag
pump.
Inadequate tools used while working. Lock out / Tag out procedures
Position of people should be respected.

PJSM to be held before starting the


job.
Make sure that the Driller is aware
about the job to be done.

Inspect the tools and equipment


prior to use.
Keep the place around the pump
clean and tidy before and after
work.

Make sure that the person working


on the pump is in a solid position.

Close out the PTW after work and


inform the driller.
Hazard effect HE:

Personal injury Environmental impact HE rating

Fatality Total loss of containment A


Likely permanent disability Significant loss of containment > 100 bbl B
Hospital stay Significant loss < 100 bbl only workplace affected C
DAFWC, MTI, treatment by doctor Minor loss < 10 bbl at workplace D
First aids Slight loss of containment < 1 bbl E

PR= probability rating (High / Medium / Low)

Prepared by A.O.O Drilling HSE Advisor

Reviewed by AOO Drilling and Workover Dept and HSE Dept – El Sharara

Approved by AOO Drilling Coordinator – El Sharara

You might also like