Issue date: 13-March-2020

Revision date: 05-April-2023

Supersedes date: 13-March-2020
Version number: 02

SAFETY DATA SHEET

Section 1 - Identification
Product identifier Husqvarna 4-Stroke OIL 10W-30 Transmission Oil
Other means of identification
Product code 597 68 70-01 (1 L), 597 68 70-04 (4 L), 597 68 70-20 (200 L)
Recommended use of the chemical and restrictions on use
Recommended use Transmission oil.
Restrictions on use Use in accordance with supplier's recommendations.
Details of manufacturer or importer
Supplier Husqvarna Australia Pty Ltd
Address 4 Pioneer Avenue, Tuggerah NSW 2252
Country Australia
Telephone +61 2 4352 7400
Contact person Jason Bezzina
E-mail [email protected]
Emergency Contact Poisons Information Centre; phone 13 12 26

Section 2 - Hazard(s) identification

Classification of the hazardous chemical
Physical hazards Not classified.

Health hazards Not classified.

Label elements, including precautionary statements

Hazard symbol(s) None.
Signal word None.
Hazard statement(s) The mixture does not meet the criteria for classification.
Precautionary statement(s)
Prevention Not assigned.
Response Not assigned.
Storage Not assigned.
Disposal Not assigned.
Supplemental information None.
Other hazards which do not None known.
result in classification

Section 3 - Composition and information on ingredients

Mixture
Identity of chemical ingredients CAS number and other Concentration of
unique identifiers ingredients
Distillates (petroleum), hydrotreated heavy paraffinic 64742-54-7 25 - 50

Composition comments All concentrations are in percent by weight unless ingredient is a gas. Gas concentrations are in
percent by volume.
Mineral oil with additives. The mineral oils in the product contain <3% DMSO extract (IP 346).

Section 4 - First aid measures

Description of necessary first aid measures
Inhalation Move to fresh air. Call a physician if symptoms develop or persist.

Husqvarna 4-Stroke OIL 10W-30 Transmission Oil SDS Australia

949437 Version #: 02 Revision date: 05-April-2023 Issue date: 13-March-2020 1/6
 Skin contact Wash off with soap and water. Get medical attention if irritation develops and persists.
Eye contact Rinse with water. Get medical attention if irritation develops and persists.
Ingestion Rinse mouth. Get medical attention if symptoms occur.
Personal protection for first-aid IF exposed or concerned: Get medical advice/attention. Ensure that medical personnel are aware
responders of the material(s) involved, and take precautions to protect themselves.
Symptoms caused by exposure Direct contact with eyes may cause temporary irritation.
Medical attention and special Provide general supportive measures and treat symptomatically. Keep victim under observation.
treatment Symptoms may be delayed.

Section 5 - Firefighting measures

Extinguishing media
Suitable extinguishing Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2).
equipment
Unsuitable extinguishing Do not use water jet as an extinguisher, as this will spread the fire.
equipment
Specific hazards arising from During fire, gases hazardous to health may be formed.
the chemical
Special protective equipment Self-contained breathing apparatus and full protective clothing must be worn in case of fire.
and precautions for firefighters
Fire fighting Move containers from fire area if you can do so without risk.
equipment/instructions
Hazchem code None.
General fire hazards No unusual fire or explosion hazards noted.
Specific methods Use standard firefighting procedures and consider the hazards of other involved materials.

Section 6 - Accidental release measures

Personal precautions, protective equipment and emergency procedures
For non-emergency Wear appropriate personal protective equipment. Keep unnecessary personnel away. Avoid
personnel breathing mist/vapours. Do not touch damaged containers or spilled material unless wearing
appropriate protective clothing.
For emergency responders Keep unnecessary personnel away. Wear safety glasses with side shields (or goggles). Wear
appropriate chemical resistant gloves. Use personal protection recommended in Section 8 of the
SDS.
Environmental precautions Avoid release to the environment. Inform appropriate managerial or supervisory personnel of all
environmental releases. Prevent further leakage or spillage if safe to do so. Avoid discharge into
drains, water courses or onto the ground.
Methods and materials for This product is miscible in water. Prevent product from entering drains.
containment and cleaning up
Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is
possible. Absorb in vermiculite, dry sand or earth and place into containers. Following product
recovery, flush area with water.

Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination.

Never return spills to original containers for re-use. Put material in suitable, covered, labelled
containers. For waste disposal, see section 13 of the SDS.

Section 7 - Handling and storage

Precautions for safe handling Provide adequate ventilation. Wear appropriate personal protective equipment. Avoid release to
the environment. Empty drums should be completely drained, properly bunged and promptly
returned to a drum reconditioner, or promptly disposed of. Do not cut, weld, solder, drill, grind, or
expose containers to heat, flame, sparks, or other sources of ignition. Avoid prolonged exposure.
Observe good industrial hygiene practices.
Conditions for safe storage, Store in tightly closed container. Store away from incompatible materials (see section 10 of the
including any incompatibilities SDS).

Section 8 - Exposure controls and personal protection

Control parameters Follow standard monitoring procedures.

Husqvarna 4-Stroke OIL 10W-30 Transmission Oil SDS Australia

949437 Version #: 02 Revision date: 05-April-2023 Issue date: 13-March-2020 2/6
Occupational exposure limits
Australia. National Workplace OELs (Workplace Exposure Standards for Airborne Contaminants, Appendix A)
Product Type Value
Oil mist, mineral TWA 5 mg/m3

US. ACGIH Threshold Limit Values

Product Type Value Form

Oil mist, mineral TWA 5 mg/m3 Inhalable fraction.

Germany. DFG MAK List (advisory OELs). Commission for the Investigation of Health Hazards of Chemical Compounds
in the Work Area (DFG)
Product Type Value Form
Oil mist, mineral TWA 5 mg/m3 Respirable fraction.
Biological limit values No biological exposure limits noted for the ingredient(s).
Exposure guidelines Provide adequate ventilation.
Control banding Not available.
Engineering controls Good general ventilation should be used. Ventilation rates should be matched to conditions. If
applicable, use process enclosures, local exhaust ventilation, or other engineering controls to
maintain airborne levels below recommended exposure limits. If exposure limits have not been
established, maintain airborne levels to an acceptable level.
Individual protection measures, such as personal protective equipment (PPE)
Eye/face protection Wear safety glasses with side shields (or goggles).

Skin protection
Hand protection Wear appropriate chemical resistant gloves. Glove material: Nitrile rubber. Use gloves with
breakthrough time of 480 minutes. Minimum glove thickness 0.35 mm.
Other Use of an impervious apron is recommended.
Respiratory protection In case of insufficient ventilation, wear suitable respiratory equipment.
Thermal hazards Wear appropriate thermal protective clothing, when necessary.

Hygiene measures Observe any medical surveillance requirements. Always observe good personal hygiene
measures, such as washing after handling the material and before eating, drinking, and/or
smoking. Routinely wash work clothing and protective equipment to remove contaminants.

Section 9 - Physical and chemical properties

Physical state Liquid.
Form Liquid.
Colour Amber.
Odour Not determined.
Odour threshold Not available.
pH Material is non soluble in water.
Melting point/freezing point Not determined.
Boiling point and boiling range Not determined.
Flash point 220 °C (428 °F)
Evaporation rate Not determined.
Flammability (solid, gas) Not applicable.
Upper/lower explosive limits
Explosion limit - lower (%) Not determined.
Explosion limit - upper (%) Not determined.
Vapour pressure Not determined.
Vapour density Not determined.
Relative density 0.8665
Solubility
Solubility (water) Insoluble.

Husqvarna 4-Stroke OIL 10W-30 Transmission Oil SDS Australia

949437 Version #: 02 Revision date: 05-April-2023 Issue date: 13-March-2020 3/6
Partition coefficient: Not applicable, product is a mixture.
n-octanol/water
Auto-ignition temperature Not determined.
Decomposition temperature Not determined.
Viscosity 71.3 mm²/s (40 °C)
Particle characteristics Not applicable, material is a liquid.
Data relevant with regard to No relevant additional information available.
physical hazard classes
Other physical and chemical parameters
Oxidising properties Not oxidising.

Section 10 - Stability and reactivity

Reactivity The product is stable and non-reactive under normal conditions of use, storage and transport.
Chemical stability Material is stable under normal conditions.
Possibility of hazardous No dangerous reaction known under conditions of normal use.
reactions
Conditions to avoid Contact with incompatible materials.
Incompatible materials Strong oxidising agents.
Hazardous decomposition No hazardous decomposition products are known.
products

Section 11 - Toxicological information

Information on possible routes of exposure
Inhalation Prolonged inhalation may be harmful.
Skin contact Frequent or prolonged contact may defat and dry the skin, leading to discomfort and dermatitis.
Eye contact Direct contact with eyes may cause temporary irritation.
Ingestion Expected to be a low ingestion hazard.
Early onset symptoms related Direct contact with eyes may cause temporary irritation.
to exposure
Delayed health effects from Prolonged inhalation may be harmful.
exposure

Skin corrosion/irritation Prolonged skin contact may cause temporary irritation.

Serious eye damage/irritation Direct contact with eyes may cause temporary irritation.
Respiratory or skin
sensitisation
Respiratory sensitisation Not a respiratory sensitiser.
Skin sensitisation This product is not expected to cause skin sensitisation.
Germ cell mutagenicity No data available to indicate product or any components present at greater than 0.1% are
mutagenic or genotoxic.
Carcinogenicity Not classifiable as to carcinogenicity to humans.
Reproductive toxicity This product is not expected to cause reproductive or developmental effects.
Specific target organ toxicity - Not classified.
single exposure
Specific target organ toxicity - Not classified.
repeated exposure
Aspiration hazard Not an aspiration hazard.
Chronic effects Prolonged inhalation may be harmful. Prolonged and repeated contact with used oil may cause
serious skin diseases, such as dermatitis and skin cancer.

Section 12 - Ecological information

Ecotoxicity Based on available data, the classification criteria are not met for hazardous to the aquatic
environment.

Husqvarna 4-Stroke OIL 10W-30 Transmission Oil SDS Australia

949437 Version #: 02 Revision date: 05-April-2023 Issue date: 13-March-2020 4/6
Persistence and degradability The product is expected to be biodegradable.
Bioaccumulative potential No data available.
Mobility in soil This product is miscible in water.
Other adverse effects Oil spills are generally hazardous to the environment.

Section 13 - Disposal considerations

Disposal methods Collect and reclaim or dispose in sealed containers at licensed waste disposal site. Do not allow
this material to drain into sewers/water supplies. Do not contaminate ponds, waterways or ditches
with chemical or used container. Dispose of contents/container in accordance with
local/regional/national/international regulations.
Residual waste Dispose in accordance with local regulations. Empty containers or liners may retain some product
residues. This material and its container must be disposed of in a safe manner (see: Disposal
instructions).
Contaminated packaging Since emptied containers may retain product residue, follow label warnings even after container is
emptied. Empty containers should be taken to an approved waste handling site for recycling or
disposal.

Section 14 - Transport information

ADG
Not regulated as dangerous goods.
RID
Not regulated as dangerous goods.
IATA
Not regulated as dangerous goods.
IMDG
Not regulated as dangerous goods.
Transport in bulk according to Not established.
Annex II of MARPOL 73/78 and
the IBC Code

Section 15 - Regulatory information

Safety, health and environmental regulations
National regulations This Safety Data Sheet was prepared in accordance with Australia Model Code of Practice for the
preparation of Safety Data Sheets for Hazardous Chemicals.
The components of this product are listed, or are exempt from listing, on the Australian Inventory
of Industrial Chemicals (AIIC)
High Volume Industrial Chemicals (HVIC)
Not listed.
Importation of Ozone Depleting Substances (Customs(Prohibited imports) Regulations 1956, Schedule 10, as amended)
Not listed.
National Pollutant Inventory (NPI) substance reporting list
Not listed.
Prohibited Carcinogenic Substances
Not regulated.
Prohibited Substances (National Model Regulation for the control of Workplace Hazardous Substances, Schedule 2
NOHSC:1005 (1994) as amended)
Not listed.
Restricted Carcinogenic Substances
Not regulated.
Restricted Importation of Organochlorine Chemicals (Customs(Prohibited Imports) Regulations 1956, Schedule 9)
Not listed.
International regulations
Stockholm Convention
Not applicable.
Rotterdam Convention
Not applicable.
Kyoto Protocol
Not applicable.

Husqvarna 4-Stroke OIL 10W-30 Transmission Oil SDS Australia

949437 Version #: 02 Revision date: 05-April-2023 Issue date: 13-March-2020 5/6
 Montreal Protocol
Not applicable.
Basel Convention
Not applicable.

Section 16 - Any other relevant information

Issue date 13-March-2020
Revision date 05-April-2023
Key abbreviations or acronyms IATA: International Air Transport Association.
used IMDG Code: International Maritime Dangerous Goods Code.
LC50: Lethal Concentration 50%.
RID: Regulations concerning the International Carriage of Dangerous Goods by Rail.
References ECHA CHEM
Disclaimer Husqvarna AB cannot anticipate all conditions under which this information and its product, or the
products of other manufacturers in combination with its product, may be used. It is the user’s
responsibility to ensure safe conditions for handling, storage and disposal of the product, and to
assume liability for loss, injury, damage or expense due to improper use. The information in the
sheet was written based on the best knowledge and experience currently available.

Husqvarna 4-Stroke OIL 10W-30 Transmission Oil SDS Australia

949437 Version #: 02 Revision date: 05-April-2023 Issue date: 13-March-2020 6/6