Scribd
Upload
21 views5 pages

Unit 1 Rocks Minerals and Their Expolitation

Uploaded by

7jhmczywzh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
21 views5 pages

Unit 1 Rocks Minerals and Their Expolitation

Uploaded by

7jhmczywzh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 5

o Igneous rocks:

 Made when liquid magma cools to form solid rock.


 Molten rock below the surface is called magma, and lava when it reaches the surface.
 Extrusive igneous rock: if the rock cools quickly, small crystals are formed e.g. basalt.
 Intrusive igneous rock: if the rock cools slowly, large crystals are formed e.g. granite.

o Sedimentary rocks:
 Formed by the weathering of existing rocks at the Earth’s surface.
 Fossils may be present.
 Sediments (small particles of rocks) accumulate into layers and get pressurised due to the
newer deposits above them.
 The sediments are transported by water and wind (erosion).
 Particles like clays, silts, sands, gravels and small boulders are found in sediments.
 Examples: limestone, sandstone and shale.

o Metamorphic rocks:
 Formed from existing rock when heat and/or pressure causes changes in the rock crystals
without melting it.
 The changes can be physical, chemical or both.
 Examples: marble and slate.
1.2 Extraction of rocks and minerals from the Earth:

 Exploring for minerals:


o Prospecting:
A process of searching for minerals by examining the surface of the rocks.
o Remote sensing: a process in which information is gathered about the Earth’s surface from
above.
 Photographs of the area are taken from air.
 The images are carefully analysed for mineral presence.
 Aerial photography can cover more ground than a person on the surface.
o Radiation detection:
 Mineral deposits are weathered at the Earth’s surface, forming mineral oxides.
 They can be detected by their unique radiation pattern (recorded by a satellite and
downloaded to a computer for analysis)
o Satellite signals:
 Some satellites send signals to the Earth’s surface and collect the reflected signals, indicating
the presence of minerals.
 The system works in all weather conditions.
o Satellite images:
 Computers are used to process the data from a region of interest to check for mineral
presence.
 Geologists confirm the presence of the mineral by visiting the location (recorded by the
satellite’s positioning system).
 Geologists can further check the availability
o Geochemical analysis: analysing the chemical properties of rocks (by taking samples).

The samples can be taken from stream sediments, soil or rocks (using shallow drilling).

 The location of the sample points can be accurately found using the Global Positioning System
(GPS).
o Geophysics: method to identify mineral ores present in rocks using their physical properties.
 A series of vibrations (seismic waves) are sent through the Earth’s surface.
 Several sensors are placed at different distances from the source of vibrations on the surface.
 The vibrations create shock waves that travel down into the rock layers.
 They are reflected back to the sensors on the surface.
 The shock waves record different patterns depending on the mineral present in the rock layers.
• Methods of extraction

 Surface mining: includes open-cast (open-pit,


opencut) and strip mining.

 Open-pit mining is used when a valuable deposit is located


near the surface.

 The vegetation is cleared and topsoil removed.

 The rocks are broken up and loosened with


explosives.
 The loose rock is removed using diggers.
 The rock or mineral is tipped into trucks or
railway wagons.
 Building materials such as sand, gravel and stone
are removed from open pits called quarries.
 Strip mining is used to mine a seam of mineral

 The overburden (overlying rock and soil) is


removed as a thin strip.
 It is mainly used to mine coal
 Sub-surface mining: includes deep and
shaft mining.
 A vertical shaft is sunk down to the rock layer
containing minerals.
 A horizontal tunnel is made, following the mineral
layer.
 The minerals are extracted by digging (by machines
and miners).
 The loose rock is brought from the mine and piled
up on waste heaps on the surface.
 The minerals are brought to the surface and
transported in trucks or trains.

• Factors that affect the decision to extract rocks and minerals:

 The costs of exploration and extraction:


 Probable cost of extracting one tonne is calculated.
 There are fewer technical difficulties of mining on a large scale using open-pit mining as there’d
be low extraction costs per tonne.
 Shaft mining is costlier to set up and maintain as the cost per tonne will be higher. So, only
deposits of higher value can be mined in this way.
 Geology:
 High-grade ores yield more of the required chemical elements than low-grade ores.
 Small deposits of high-grade ore are worth mining.
 Small deposits of low-grade ore that cannot be mined at a profit are left as reserves.
 Accessibility:
 Transporting the ore from the mine to processing plants can be difficult and expensive.
 The cost of building road or rail links to the processing plant or to the nearest port for
export has to be considered.
 Carrying out some processing at the mine reduces transport costs.
 The mining company must be given a licence before extracting a deposit.
 A long-term agreement between the government and mining company must be reached to
avoid rapid rises in the tax, which makes the mining unprofitable.
 Environmental impact assessment:
 For a licence application to be approved, the company must have a plan to keep the loss
of habitat minimal, followed by the restoration of land proceeding the completion of
mining.
 The choice of site for mine waste should also be considered.
 Supply and demand: the relation between how much of a commodity is available and how
much is needed or wanted by the consumers.
 Increase in world demand for any mineral ore will elevate the prices.
 The profit from a working mine depends on changes in supply and demand.
 If the demand is too high, mines that were not profitable before become worth mining.
 If the demand falls, working mines may get into a loss due to the transport and
extraction expenses.

You might also like