Scribd
Upload
53 views

Drilling and Tapping

Uploaded by

Susbehe
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
53 views

Drilling and Tapping

Uploaded by

Susbehe
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Ex.

No: Date:
DRILLING AND TAPPING

Aim:

To make an internal thread on agiven work piece as per the required dimensions using
drilling machine and tapping tool.

Tools Required:
1. Machine vice 2. Drilling machine

3. Drill bit 4. Tapping tool

5. Dot punch 6. Hammer etc.

Procedure:
requirement.
dimensions of the given work piece are checked as per the
1. The angle.
clamped in the vice and any two surfaces are filed to get right
2. The work piece is
is fitted in the drill chuck of the drilling machine.
3. Drillbit of required size dot punch and hammer.
required hole is punched by using
4. The midpoint of the drillingmachine.
is drilled by
5. The punched dot tap tool.
drilling the hole, they are tappedbý using
6. After
Finally, the dimensions arechecked,
7.

Result:
drilled and tapped to the required dimensions.
Thus the given work piece is
'holes
D8.5 M10 Thread Two

25
25

50

Dimensighs After Machin1ng

You might also like