Scribd
Upload
6 views

SCRE-02 Isothermal C.S.T.R

Uploaded by

Abhishek Aggarwal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
6 views

SCRE-02 Isothermal C.S.T.R

Uploaded by

Abhishek Aggarwal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

SUPERB TECHNOLOGIES

AN ISO 9001:2008 CERTIFIED CO.


MANUFACTURER & SUPPLIER OF ENGINEERING LAB EQUIPMENT
Add. – 80 INDUSTRY AREA, AMBALA CANTT, HARYANA.(133001)
CONTACT NO. – 09896915524
E-mail : [email protected]

Isothermal Continuous stirred Tank Reactor (SCRE-02)

GENERAL DISCRIPTION

In an ideal CSTR (i.e. an ideal steady state flow reactor) the contents
in reactor are well mixed and have uniform composition throughout.
Thus the exit stream has the same composition as the fluid within the
reactor. This type of reactor is known as mixed flow reactor. This set-
up is used to study a non-catalytic homogeneous second order liquid
phase reaction under isothermal condition. The set up consists of two
feed tanks through which two reactants are fed to the reactor. Rota
meters are provided to measure the individual flow of Chemicals. The
flow rate can be adjusted by operating the needle valves provided on
respective Rota meter. The compressed air is used for circulation of
feed. The CSTR is fitted with stirrer for proper mixing. From top
outlet of it samples are collected for analysis. Constant temperature
water bath arrangement is provided to conduct the experiment at
various temperatures. Pressure Regulator, Pressure Gauge and Safety
Valve are fitted in the compressed air line.

EXPERIMENTATION

➢ Sponification Reaction study in Isothermal CSTR.


➢ To determine the Reaction Rate Constant and effect of temperature on it

SPECIFICATIONS SERVICES REQUIRED

➢ Reactor : Material Stainless Steel, Capacity 2 Ltrs. (Approx). ➢ Compressed Air Supply at 2
➢ Water Bath : Material Stainless Steel, Double wall, insulated with Ceramic Bar, 0.5 CFM.
Wool ➢ Electricity Supply : 1 Phase,
➢ Heater : Nichrome wire Heater 220 V AC, 1.5 kW.
➢ Stirrer (2Nos.): Stainless Steel Impeller and shaft coupled with FHP motor. ➢ Instruments, Laboratory
(One each for Water Bath and Reactor). Glassware and Chemicals
➢ Feed Tank (2Nos.): Material Stainless Steel, Capacity - 20 Ltrs. required for analysis as per
➢ Feed Circulation: By compressed air. the system adopted.
➢ Flow Measurement: Rotameter 2 Nos. one each for Reactants.
➢ Piping : Stainless Steel and PVC.
➢ Pressure Regulator : 0-2 Kg/cm2
➢ Pressure Gauge : Bourdon type 0-2 Kg/cm2
➢ Stop Watch : Electronic
➢ Temp. Sensor : RTD PT-100 type
➢ Control panel comprises of : Digital Temp. Controller : 0-199.9°C (For Hot
Water Bath) With Standard make on/off switch, Mains
➢ Indicator etc.
➢ Instruction Manual : An ENGLISH instruction manual will be provided
along with the Apparatus
➢ The whole unit is assembled rigidly on a base plate and mounted on a stand.
➢ .
❖ Specifications subject to change without any prior notices , due to convenience of product improvement.

You might also like