ZONE TECH Circuit 1

ZONE TECH
Best Institute For ASSISTANT & JUNIOR ENGINEER

Test ID. 272 Roll No.

CH
ELECTRICAL ENGINEERING
Circuit Mains Test Paper
Duration : 2:00 hr.
TE Maximum Marks : 300
Read the following instructions carefully
1. Candidates should be attempt 5 questions in all. All question carry equal marks.
2. Each condidate will be given one Answer Book.
3. Answers to all questions must be written in one language, i.e. , either in English
E
or in Hindi according to the option given by the candidate in his/her Application
Form. Candidates are not allowed to write the answers partly in English and
N

partly in Hindi.
4. Candidates must write their Name , Roll No., Name of the Examination and
Subject at the prescribed place on the cover page of the Answer Book correctly.
ZO

Candidates must also put their signature,The above instrucations must be fully
complied with failing which the Answer Book with not be evaluated and zero
mark will be awarded.
5. No credit will be given for answer written in a language other than the one
opted by the candidate.
6. Mobile phones and wireless communication devices are completely banned in
the examination halls/rooms. Candidates are advised not to keep mobile phones/
any other wireless communication devices with them, even switching it off, in
their own interest. Failing to comply with this provision with be considered as
using unfair means in the examination and action will be taken against them
including cancellation of their of their candidatiure.

DO NOT OPEN THIS TEST BOOKLET UNTIL YOU ARE ASKED TO DO SO

Call Us : 0141-2597591, +91-9828747676 ZONE TECH F-26/A Kisan Marg,Tonk Phatak, Jaipur
ZONE TECH Circuit 2
Q.1 Q.2
(a) Calculate the equivalent resistance Rab in (a) Explain the following terms
the circuit below. (i) Active & passive element
(ii) Linear & Non-linear element
(iii) Unidirectional and bidirectional
a 10 1 d 1
c element.
6 [10 Marks]

5 5
Rab 3 (b) In the circuit of figure, find the value of
supply voltage V so that 20–  resistor can
12
dissipate 180 W.

H
b b b

I A I2 10  I4
C
[20 Marks]

C
I1 I3

(b) By using mesh Analysis find current I 0 in V 25  15  20 

the circuit.

24V + 10
I0
24
TE E
5

B D

[20 Marks]
4
12 +
E
4I0
(c) The voltage across 5 H inductor is
30t 2 t0
V t  
N

[20 Marks] 0 t0

Find the energy stored at t = 5 s. Assume

zero initial current.
(c) Find VAB for the circuit shown below using
ZO

[20 Marks]
source transformation
(d) The power delivered by the current source,
4 in the figure shown is.

+–
1V
1 1
+ 1V 2A 1
–

[20 Marks]
[10 Marks]

Call Us : 0141-2597591, +91-9828747676 ZONE TECH F-26/A Kisan Marg,Tonk Phatak, Jaipur
ZONE TECH Circuit 3
Q.3 (b) A 3 ph load has a resistance of 10 in each
(a) State and prove maximum power transfer phase and is connected in (i) star and (ii)
theorem for dc circuits. delta against a 400 V 3 ph supply. Compare
[20 Marks] the power consumed in both the cases.
[20 Marks]
(b) State and explain Norton's theorem
[20 Marks]
(c) For the parallel circuit shown in the figure
(c) Determine the thevenin's equivalent ckt. draw a neat phasor diagram and determine
across 3-ohm resistor for the circuit shown an expression for the value of the capacitor

CH
in figure below. C for the circuit to exhibit the unity power
factor.

6 IL

IC R
+
V C
1 15A –

20V
+
–
2
15A 3
TE L

[20 Marks]

Q.5
E
[20 Marks] (a) Calculate the value oF R C in the circuit
shown in figure to yield resonance.
Q.4
N

(a) In the network shown in Figure. Find I when

a 200 V AC 50 Hz voltage is applied at the
input.
RC
ZO

10

j10 –j2

[20 Marks]

(b) Explain the resonance for series RLC ckt.

having resonant frequency W0 .
[20 Marks]
[20 Marks]

Call Us : 0141-2597591, +91-9828747676 ZONE TECH F-26/A Kisan Marg,Tonk Phatak, Jaipur
ZONE TECH Circuit 4
(c) Define the following terms: (c) Define the following terms:
(i) Resonance (i) Magnetic field intensity
(ii) Q-factor (ii) Magenetic flux density
[10 Marks] (iii)Magnetomotive force
(iv)Reluctance
(d) An incandescent lamp is marked 40W, [20 Marks]
240V. If resistance at room temperature
(26°C) is 120  , and temperature coefficient
(d) The voltage and current waveforms for an
of resistance is 4.5 × 10–3/°C, then its 'ON'
element are shown in figure. The circuit
state filament temperature in °C is

H
element is .........and its value is............
approximately.
[10 Marks]
i(t) v(t)

C
Q.6
2V 2V
(a) Two mutually coupled identical coils are
connected in series having self inductance
L = 4 mH and mutual inductance M = 2
mH, what is the maximum ratio of two
possible value of two possible values of
TE 0 2s
t
0 2s
t

effective inductance ? [20 Marks]

[10 Marks]
E

(b) A mild steel ring has a mean diameter of

20 cm and a cross-sectional area of 50 cm 2
N

for a relative permeability of 800, calculate.

(i) Reluctance of the ring.
ZO

(ii) Current required in 200-turn coil to

produce a flux of 1 mwb in the Ring.
[10 Marks]

Call Us : 0141-2597591, +91-9828747676 ZONE TECH F-26/A Kisan Marg,Tonk Phatak, Jaipur