Scribd
Upload
26 views

Electronic Devices and Circuits

This describes brief about electronic devices and circuits

Uploaded by

Raj Ghimire
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
26 views

Electronic Devices and Circuits

This describes brief about electronic devices and circuits

Uploaded by

Raj Ghimire
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

POKHARA UNIVERSITY

Level: Bachelor Semester : Spring Year : 2023


Programme: BE Full Marks: 100
Course: Electronic Devices and Circuits Pass Marks: 45
Time : 3hrs.

Candidates are required to give their answers in their own words as far
as practicable.
The figures in the margin indicate full marks.
Attempt all the questions.

1. a) What are different types of semiconductors? Explain the effect of 7


temperature in ordinary p-n junction diode.
b) For the circuit shown in figure below find: 8
i) The output voltage
ii) Voltage drop across the series resistance
iii) Current through the Zener diode

Also, Draw IV characteristic curve of Zener diode


2. a) Explain the input and output characteristics of common emitter 7
transistor with necessary diagrams and characteristic curve.
b) For the BJT common emitter circuit shown below, determine the 8
operating point and locate it in the dc load line. Assume β = 100.
Also find VC and VE

1
3. a) What is rectification? Explain the operation of half wave rectifier 7
circuit with necessary circuit diagrams and waveforms.
b) For the circuit given, Find out drain current and drain to source voltage 8
at operating point. Given IDSS = 8 mA, Vp = -6 V, RD = 3.3kΩ, RS =
1000 Ω, R2 = 1 MΩ, VDD =30V. Indicate value of operating point in
characteristic curve

4. a) Find overall voltage gain using re model. Assume β = 100. 8

2
b) Using re model, find VL/VS for the cascaded BJT amplifier given below. 7
Assume re1 = re2 = 20 Ω , β1= β2= 100

5. a) What do you mean by power amplifier? Show that maximum possible 7


efficiency of transformer coupled load class A power amplifier is 50
%.
b) Negative feedback decreases the gain but increases the gain stability
8
in a feedback amplifier. Do you agree with this statement? Justify
your answer. The overall gain of a multistage amplifier is 140. When
negative feedback is applied, the gain reduces to 17.5. Find the
fraction of the output that is feedback to the input.
6. a) What is the importance of positive feedback on oscillator circuits? 8
Explain RC phase shift oscillator with its necessary derivations.
3
b) Design an operational amplifier that produces an output equal to 7
Vo=-2V1+8V2-3V3+ 6V4.
7. Write short notes on: (Any two) 2×5
a) Regulated and unregulated power supply
b) Small signal model of AC
c) Concept of DC and AC analysis

You might also like