Scribd
Upload
36 views

Control System Engineering: (Level/CO) Marks CO1 CO1 CO1

Swn

Uploaded by

niteshrane36
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
36 views

Control System Engineering: (Level/CO) Marks CO1 CO1 CO1

Swn

Uploaded by

niteshrane36
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

DR.

BABASAHEB AMBEDKAR TECHNOLOGICAL UNIVERSITY, LONERE


Summer Examination – 2023
Course: B. Tech. Branch :Electrical Semester :VI
Subject Code & Name: BTEEC603 Subject: Control system Engineering
Max Marks: 60 Date: Duration: 3 Hr.
Instructions to the Students:
1. All the questions are compulsory.
2. The level of question/expected answer as per OBE or the Course Outcome (CO) on
which the question is based is mentioned in ( ) in front of the question.
3. Use of non-programmable scientific calculators is allowed.
4. Assume suitable data wherever necessary and mention it clearly.
(Level/CO) Marks
Q. 1 Solve Any Two of the following. CO1 12
A) Explain signal flow graph in detail with the help of Masons gain formula. CO1 6
B) Using the block diagram reduction technique, find the closed loop CO1 6
transfer function of the system whose block diagram is given in figure.

C) Obtained the analogous electrical network for the system shown in 6


figure.
Q.2 Solve Any Two of the following. 12
A) A unity feedback system has G(s) = 𝟐𝟎(𝒔+𝟑) Determine type of system, CO2 6
(𝒔+𝟏)(𝒔+𝟔)

all error coefficient, error when subjected to a step of magnitude 2.


B) Determine the stability using Routh’s Criteria : s5+2s4+3s3+6s2+2s+1 CO2 6
C) Check whether the given system is stable or not by using Hurwitz CO2 6
criterion.

Q. 3 Solve Any Two of the following. 12


A) Derive the transfer function of lead compensator using electrical CO3 6
network.
B) Draw the approximate root-locus diagram for close loop system whose CO3 6
𝒌
transfer function is given by G(s)H(s)=
𝒔(𝒔+𝟓)(𝒔+𝟏𝟎)

C) Sketch the Bode plot showing the magnitude the decibel and phase angle CO3 6
in degrees as a function of log frequency for the transfer function given
below. Determine the gain cross-over frequency 𝝎gc .
𝟏𝟎
𝑮(𝒔) =
𝒔(𝟏 + 𝟎. 𝟓𝒔)(𝟏 + 𝟎. 𝟎𝟏𝒔)

Q.4 Solve Any Two of the following. 12


A) Write a short note on PI controller and PID controller. CO4 6
B) What are the effects of proportional, integral and derivative control on CO4 6
the time response of the system.
C) A PI controller is used to control a system. It has the following settings, CO4 6
kp = 2%, ki = 3% per minutes, m(0) = 25%. The error signal is found to
be 4t + 2. Find the controller output in percent after 2 minutes.

Q. 5 Solve Any Two of the following. 12


A) Obtain the state model for the system with the transfer function CO5 6
𝟑𝒔+𝟒
𝒚(𝒔) = 𝒔𝟐+𝟓𝒔+𝟔

B) Find the state transition matrix for, 𝑨 = [ 𝟏 𝟎


] CO5 6
−𝟔 −𝟓
C) A linear time invariant system is characterized by the state variable CO5 6
model. Comment on the controllability and observability of the system.

𝑿𝟏̇ −𝟏 𝟎 𝑿𝟏 𝟎
[ ]=[ ] [ ] + [ ] 𝒖(𝒕)
𝑿𝟐̇ 𝟎 −𝟐 𝑿𝟐 𝟏

𝑿
𝒀(𝒕) = [𝟏 𝟐] [ 𝟏 ]
𝑿𝟐
*** End ***

You might also like