Mid Assignment IEC
Mid Assignment IEC
Introduction to Electrical
Course Name: Course Code: COE 2101
Circuits
Semester: Spring 22-23 Sec: U
Faculty: Mehedi Azad Shawon Term: Mid
Marks: 20 Assignment Name: Assignment
Secured
Objectives [4] [3-2] [0~1]
Marks
Response shows clear systematic Problem is solved partially; response indicates The solution is
Problem 1
and theory-based understanding. theory knowledge is clear but fail to apply. incorrect.
Response shows clear systematic Problem is solved partially; response indicates The solution is
Problem 2
and theory-based understanding. theory knowledge is clear but fail to apply. incorrect.
Response shows clear systematic Problem is solved partially; response indicates The solution is
Problem 3
and theory-based understanding. theory knowledge is clear but fail to apply. incorrect.
Response shows clear systematic Problem is solved partially; response indicates The solution is
Problem 4
and theory-based understanding. theory knowledge is clear but fail to apply. incorrect.
Response shows clear systematic Problem is solved partially; response indicates The solution is
Problem 5
and theory-based understanding. theory knowledge is clear but fail to apply. incorrect.
Total
Instructions:
1. Use this page as a cover page for this assignment submission. A different cover page or no cover page,
assignment submission will not be acceptable.
2. You MUST draw the circuit with your ID values whenever it is needed/ asked in the question.
3. No late submission is allowed.
4. Copied/identical submissions will be graded as 0 for all parties concerned.
Introduction to Electrical Circuits (COE 2101) Spring 22-23 Semester
Three different types of DC sources are available (Fig-1 below), and all are connected in parallel, (a)
12V IPS battery, (b) a 12V dry cell and (b) 12V DC supply from laboratory.
Now each of the supply has an internal resistance of ‘a’, ‘b’ and ‘e’ Ω (respectively). Now, a load of
‘cd’ Ω is connected to the end of the combined parallel supply. (Any value comes ‘0’ need to consider
‘9’ for your assignment)
1. Considering the case study mentioned above, apply network theorem to determine the
power delivered at load and lost to the internal resistance of the supplies.
2. Determine the load for maximum power transfer condition for each of the power supplies [4]
and connecting them all in parallel.
3. If you have control over the internal resistance, then determine the value of internal [4]
resistance for Maximum power to the load.
4. If a capacitor (‘eb’ µF) is connected series with the load at maximum power transfer, then [4]
sketch the behavior of the transient response of the system when connecting all power
supplies parallel with load.
5. Show all the circuit configurations in simulation along with output/responses [4]
==============THE END================