18-DEC-2023 56312E30

RYLR998

UART Interface
868/915 MHz LoRa®
Antenna Transceiver Module

Datasheet
 RYLR998
868/915MHz LoRa® Antenna Transceiver Module

PRODUCT DESCRIPTION
The RYLR998 transceiver module feature the LoRa® long range modem that provides ultra-long range
spread spectrum communication and high interference immunity whilst minimizing current
consumption.

FEATURES
• NUVOTON MCU & Semtech LoRa® Engine
• Excellent blocking immunity
• Smart receiving power saving mode
• High sensitivity
• Control easily by AT commands
• Built-in antenna
• Command support data encryption

APPLICTIONS
• IoT Applications
• Mobile Equipment
• Home Security
• Industrial Monitoring and Control Equipment

CERTIFICATION
• FCC

• CE RED

• NCC

Copyright © 2021, REYAX TECHNOLOGY CO., LTD. 2

 RYLR998
868/915MHz LoRa® Antenna Transceiver Module

PIN DESCRIPTION

RYLR998

REY AX
RY LR998
1

RYLR998_M4
Connector slot that can use I-PEX®
MHF4® connector to connect with
External Antenna

Pin Name I/O Condition

1 VDD I Power Supply
2 NRST I RESET(Active Low) 100KΩ Internal pull up,
Pull down at least 100ms
3 RXD I UART Data Input
4 TXD O UART Data Output
5 GND - Ground

Copyright © 2021, REYAX TECHNOLOGY CO., LTD. 3

 RYLR998
868/915MHz LoRa® Antenna Transceiver Module

TIMING DIAGRAM

VDD

RST

TXD Keep Low before power on Keep Low before power off

RXD Keep Low before power on Keep Low before power off

POWER ON TX/RX POWER OFF

BLOCK DIAGRAM

Switch

Filter
Processor

NUVOTON MCU Semtech LoRa®

Engine
GPIO NRST
TXD RXD
RXD TXD

Crystal

Copyright © 2021, REYAX TECHNOLOGY CO., LTD. 4

 RYLR998
868/915MHz LoRa® Antenna Transceiver Module

SPECIFICATION
Item Min. Typical Max. Unit Condition
VDD Power supply 2.3 3.3 3.6 V VDD
RF Output power range 0 22 dBm RF Output Power must be
set to less than
AT+CRFOP=14 to comply
with CE certification.
Filter insertion loss 1 2 3 dB
RF Sensitivity -129 dBm
RF Input level 10 dBm
Frequency range 820 868/915 960 MHz
Frequency accuracy ±10 ppm
Transmit Mode current 140 mA RFOP = +22dBm
Receive Mode current 17.5 mA @VDD=+3.3V
Sleep mode current 10 uA AT+MODE=1
@VDD=+3.3V
Smart receiving power 0.02 2.7 5.5 mA 2.7mA @AT+MODE=2,3000,3000
saving mode average If you need lower current
current consumption, you can adjust the
AT+MODE=2 parameter.

Baud rate 300 115200 115200 bps 8, N, 1

Digital Input Level High 0.7*VDD VDD V VIH

Digital Input Level Low 0 0.3*VDD V VIL
Digital Output Level High 0.9 VDD V VOH
Digital Output Level Low 0.1 V VOL
Cycling (erase / write) 200 K Cycles
Flash data memory
Weight 1.83 g
Operating temperature -40 25 +85 ˚C

Copyright © 2021, REYAX TECHNOLOGY CO., LTD. 5

 RYLR998
868/915MHz LoRa® Antenna Transceiver Module

DIMENSIONS

Copyright © 2021, REYAX TECHNOLOGY CO., LTD. 6

 RYLR998
868/915MHz LoRa® Antenna Transceiver Module

Unit : mm

*For more detail, please refer to the 3D model Information.

Copyright © 2021, REYAX TECHNOLOGY CO., LTD. 7

 RYLR998
868/915MHz LoRa® Antenna Transceiver Module

CERTIFICATION INFORMATION
Taiwan NCC Statement 低功率電波輻射性電機管理辦法:

第十二條 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設
計之特性及功能。

第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾
時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、
科學及醫療用電波輻射性電機設備之干擾。

CCAQ22Y10060T2

FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.

LABEL OF THE END PRODUCT:

The final end product must be labeled in a visible area with the following " Contains TX FCC ID : QLY-RYLR896 ". If the size of the end
product is larger than 8x10cm, then the following FCC part 15.19 statement has to also be available on the label: This device complies
with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference
and (2) this device must accept any interference received, including interference that may cause undesired operation.

QLYRYLR998

ETSI EN 300 220-1 V3.1.1 (2017-02)

ETSI EN 300 220-2 V3.2.1 (2018-06)

Copyright © 2021, REYAX TECHNOLOGY CO., LTD. 8

 RYLR998
868/915MHz LoRa® Antenna Transceiver Module

ORDER INFORMATION
Ordering No. Pin Header Antenna or I-PEX® MHF4® Connector
RYLR998 90 Degree Angle Antenna
RYLR998_M4 90 Degree Angle I-PEX® MHF4® Connector
RYLR998_NP Not mount Antenna

E-mail : [email protected]
Website : http://reyax.com

Copyright © 2021, REYAX TECHNOLOGY CO., LTD. 9