Scribd
Upload
10 views

Power Measurement in A Three-Phase System

Uploaded by

Ezedin Osman
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
10 views

Power Measurement in A Three-Phase System

Uploaded by

Ezedin Osman
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

electrical-engineering-portal.com http://electrical-engineering-portal.

com/power-measurement-in-a-three-phase-system

Power Measurement In a Three-Phase System


Google+

Power Measurement In a Three-Phase System (on photo: Traditional power meter)

Wattmeter
Electrical power is measured with a wattmeter. A wattmeter consists of a current coil connected in series with
load, while the other potential coil is connected parallel with load.

Depending on the strength of each magnetic field movement, the pointer gets affected.

The true or real power is directly shown in a wattmeter. In three-phase systems, power can be measured using
several methods. For temporary measurements, a single wattmeter can be used.

However, for permanent measurements, a three-phase wattmeter having two elements is used which indicates
both balanced and unbalanced loads.

For an unbalanced load, two wattmeters must be used as shown in the Figure 1.

The total power is calculated by adding the measurement readings given by the two wattmeters. With this
method, the power factor can also be obtained.

When using the two-wattmeter method, it is important to note that the reading of one wattmeter should be
reversed if the power factor of the system is less than 0.5. In such a case, the leads of one wattmeter may have
to be reversed in order to get a positive reading. In the case of a power factor less than 0.5, the readings must be
subtracted instead of being added.

The power factor of the three-phase system, using the two-wattmeter method (W1 and W2) can be calculated
as follows:

Since the sum and subtraction of readings are done to calculate total true power of
a three-phase system, methods shown are not used practically in industry.

Rather three-phase power analyzers are used which are more user-friendly.

Power Factor Meter


What’s common for Beer Mug and Power Factor? Learn.

It is similar to a wattmeter in principle, only two armature coils are provided with mountings, on a single shaft.
They are 90° apart from each other.

Both armature coils rotate as per their magnetic strengths. One coil moves proportional to the restive component
of the power, while the other coil moves proportional to the inductive component of the power.

Energy Meter
This shows the amount of power
(electric energy) used over a
certain period. In a watthour
meter, there are two sets of
windings.

One is the voltage winding while


the other is the current winding.
The field developed in the voltage
windings causes current to be
induced in an aluminum disk. The
torque produced is proportional to Figure 1 - Methods of measuring the power in three-phase systems: (a) One wattmeter method for
balanced load; (b) Two wattmeter method for balanced/unbalanced loads
the voltage and current in the
system.

The disk in turn is connected to numeric registers that show electric energy used in terms of kilowatt-hours.

Reference: Practical Troubleshooting of Electrical Equipment and Control Circuits – M. Brown

You might also like