Software Settings

1.4
Packing List Circuit Principle Update Firmware 1. Open progisp.exe Install BL touch Circuit Wiring Platform Adjustment 3 . Control→Motion-Z Offset→write down the value of 4.Prepare—>Bed Leveling（Different 3D printers may Test passed: leveling is completed and you can print Software Settings
2. Select Chip “ATmega1284p”. B, then rotate the knob until it comes out as: C = B + have different numbers of touching points for auto- now;
3. Click ...→ Set Low Value = D6 Highvalue = DC, ExtValue=FD →

8 bit
Mainboard
Creality V1
1.Prepare → Auto home,and wait until it stops. A . Return Control and Select Store settings . matic leveling.）
Click Write and close the window.
Manual 4. load Flash → Select *.hex file.(Please download the firmware
Test failed:If model printing fails, please fine-tune
Probe Z Offset again and save settings until the print-
AUTO BED LEVELING SENSOR FOR 3D PRINTER for your printer model to the computer. The firmware download
Connectors ing effect is good.
link is: https://www.creality.com/download） cable
Apply to 8-bit motherboards 5. Click Auto to update firmware, wait until it finished, then close.
6. Unplug the ISP Pinboard from mainboard. Note: Every machine has its own operation interface. 1. Open Slicer.
1. Insert connectors into 5 Pin Port.
2. Install BL Touch on the rack with 2 M3*6 screws.
BL Touch Tie
1. Connect ISP Pinboard and Burner.
2. Open the control box and find out the mainboard. Model Printing
3. Insert the ISP Pinboard into the mainboard 2x3 pins as the sign 2. Prepare→Move axis→Move Z-Move 0.1mm→Rotate
the knob until the distance between them is about After the automatic leveling, user can do a trial print to
shows.
4. Insert the Burner into computer USB port. 0.1mm (as a sheet of A4 paper), write down the value verify the leveling.
of A. 2. Settings → Printer → Manage Printers.
Operation：Print from TF →Model Test (Name and file
1. Unplug the screen cable, connect the pinboard of the testing model shall be prepared by user.）
Rack Pinboard A M3*6 2PCS M3*8 2PCS
A to the screen port. 0.1mm 4. Change “G28” to “G28G29” .
2. Insert the screen cable into 10 pins port. Main
3. Loosen all fan cover screws, install the BL Touch rack 3. Insert the connectors to the 3 pins port as the Ender3 Bed Level Test
meilanz j-29h-107g.gc
on the corresponding position with 2 M3*8 screws. sign shows. Note: The specific operation video can be watched at
Application: Ender-5 | Ender-5S | Ender-5 Pro huxingdz-69h-217g.gc
Ender-3 | Ender-3S | Ender-3Pro | CR-10 | CR-10Mini 4. Tie the BL Touch cable together with other printer 4. Unplug the Z limit switch(Z-stop port), and Robot-t10-71.8h-400g 3. Machine Settings. the following link:
ISP Pinboard Burner cables like the above picture shown. insert the connectors. https://www.youtube.com/watch?v=2B4qdKdqJj4