Scribd
Upload
35 views

Cutting Plotter Instructions.1 ARTCUT

Uploaded by

Alexandre Figueiredo
Copyright
© © All Rights Reserved
Available Formats
Download as RTF, PDF, TXT or read online on Scribd
35 views

Cutting Plotter Instructions.1 ARTCUT

Uploaded by

Alexandre Figueiredo
Copyright
© © All Rights Reserved
Available Formats
Download as RTF, PDF, TXT or read online on Scribd
You are on page 1/ 7

Cutting Plotter Instructions

First the driver installation (for USB, serial port without having to install)

For the cutting plotter's USB port, you must install the driver before you can use the
following specific steps:

1- with a USB cable connected to your computer and plotter, and then turn on the
power, this time on the computer screen will prompt you to a new hardware not
recognized.
2- the driver CD into the drive, and then double-click the drive icon will see the
following screen.
3- Click the button-CH340_341 Drive, with the installation. After installation is
complete, the computer will prompt you to install the new hardware has been
successfully.

Second the port settings

1-Click the Start menu, choose Settings - Control Panel.


Open the following screen, double-click the System icon, open the menu, select
Device Manager.
2-launched after the port is shown below.

Double-click the port (red area), can be set as follows

Then click the button-advanced, according to the following settings. Determined after
the completion point

This allows you to complete the set of USB ports, you can open the software for the
output of the

Third on some settings Wentai

1- Open Clementi, first set


First click on the icon on the toolbar carving , will open the following:
It prompts you to select the manufacturer, please select seiki., And select your
model, and finally click the Add button to complete the Close button to exit after
the point.
2- Then you will see

Click the button-setup, press the following settings. Click OK after

(Using the serial port, select com1, use the USB port select com4)
After completing the above steps click cut / polt complete output.

If you can not be exported in accordance with the above settings, it may be a problem
with your computer system, please try another computer replacement
Fourth additional instructions

1- Do not insert the serial and USB ports at the same time, it will affect the
normal operation of the machine, may seriously damage the machine
2- When the conversion of 2-port, switch off the machine
3- If your computer has two serial ports, such as com1, com2. Please note that
when using the USB port, we must first be stopped com2

4-If you can not be exported in accordance with the above settings, it may be a
problem with your computer system, please try another computer replacement

You might also like