Translated from Chinese (Simplified) to English - www.onlinedoctranslator.

com

MCRB

MCRB Instructions

Please read carefully before use

R
 MCRB

Receiver analysis

(S) Signal (-)negative electrode

Contact frequency binding

After the receiver is powered on, the contacts

Press the button to turn on the remote control (+) Positive pole

Source switch, frequency binding successful

Product parameters

model:MCRB
Color:⊊⊊

Application: fixed wing, multi-axis, vehicle, ship

Channel output: 1 PWM signal channel, 1 MBUS signal channel

Frequency band: MHz-MHz

US: WordLength Bit

Frequency mode: contact frequency matching

Close distance:>m

Receiver power supply voltage: DC.-V

Control: None

Reproducibility: fast signal recovery

Wire type: built-in antenna

⼨(length, width and height): 4mm*mm*1mm

Weight: g

R
 MCRB

Receiver and transmitter frequency binding steps

1.Turn off the transmitter, connect the signal line of the ESC to the third channel of the receiver, and then connect the ESC to the battery to power on.

2.After the receiver is powered on, the orange indicator light on the receiver will flash slowly.

3.Use a small screwdriver to gently press the "BIND”small white dot(Remember to click once),The orange indicator light on the receiver will slow down.

The flashing turns into a rapid flashing.

4.Adjust the transmitter oil rocker to the lowest position, then turn on the transmitter. The orange indicator light on the receiver will flash from fast to

Always on.

5.When the orange indicator light on the receiver is always on, it means that the receiver has aligned the frequency, aileron servo, elevator servo and direction servo.

Connect to the receiver, the wiring method is carried out according to the user's model instruction manual.

6.Make sure your transmitter can fully control the bound receiver, and then check that each channel is functioning properly.

7.If the test fails, weight the entire process.

8.After the receiver is paired with the frequency, theM.BUSConnect with the controller and adjust the multi-axis actuator according to the controller parameter adjustment software.

Parameter and calibration (M.BUSThe output signal is the same as the generalS.BUSThe signal is the same).

Precautions

Please read the following relevant precautions carefully before starting to use it!

1. Please do not use it at night or in thunderstorms, snowy days, low energy temperatures, or other severe weather environments.

2. Please do not use it in places with snow or water; if water enters the receiver, the circuit will be short-circuited and it will not be able to be used.

3. Please do not use this product when you feel tired or uncomfortable, or after drinking alcohol, or taking intoxicating or stimulating drugs, otherwise it may cause serious harm.

Seriously harm yourself or others.

4.2.4G wireless band is completely different from the low-frequency radio band used before; please make sure that the model product is in your sight when using it.

If you walk within the wireless range, large obstacles will block the wireless signal and cause the remote control and model to lose control.

5. When you stop using the remote control, be sure to cut off the power of the receiver and then turn off the transmitter; if you turn off the power of the transmitter first, then connect the

If the retractor is still working, it may cause the model to lose control or the engine to continue to work, resulting in a serious accident.

6. The transmitter and receiver required for the Mike Electronics 2.4G wireless system are in pairs, and the transmitters and receivers of other manufacturers cannot be combined with each other.

Mike is compatible.