5/2-Directional Valve, Series ST
5/2-Directional Valve, Series ST
Materials:
Housing Stainless steel, hardened
Seals Acrylonitrile Butadiene Rubber
Front plate Polyamide
Threaded bushing Brass
Technical Remarks
■ The min. control pressure must be adhered to, since otherwise faulty switching and valve failure may result!
■ The pressure dew point must be at least 15 °C under ambient and medium temperature and may not exceed 3 °C.
■ The oil content of compressed air must remain constant during the life cycle.
■ Use only the approved oils from AVENTICS, see chapter „Technical information“.
■ Notice: This product may only be operated with oiled compressed air.
1) Caution: The minimum control pressure depends on the working pressure (see “Control pressure” diagram below).
Nominal flow Qn at 6 bar and Δp = 1 bar
Supplementary products
Part numbers marked in bold are available from the central warehouse in Germany, see the shopping basket for more detailed informa-
tion
Pneumatics catalog, online PDF, as of 2014-10-22, ©AVENTICS S.a.r.l., subject to change
2
Directional valves ► Supplementary products
Control pressure
00107771
Fig. 1
00107772
Fig. 2
00107773
Supplementary products
Part numbers marked in bold are available from the central warehouse in Germany, see the shopping basket for more detailed informa-
tion
Pneumatics catalog, online PDF, as of 2014-10-22, ©AVENTICS S.a.r.l., subject to change
3
Directional valves ► Supplementary products
Fig. 3
00107774
Supplementary products
Part numbers marked in bold are available from the central warehouse in Germany, see the shopping basket for more detailed informa-
tion
Pneumatics catalog, online PDF, as of 2014-10-22, ©AVENTICS S.a.r.l., subject to change